Independent RCG01A User manual

RCG01A 31A
RCG01A - GARAGE & GATE
REMOTE PROGRAMMING
The following procedure is for programming a RCG01A remote to your garage roller door:
On the receiver board locate
the ‘S1’ or ‘Learn’ programming
button. It will be situated next to
the courtesy light globe and a
red LED.
Press and release the
‘S1’ or ‘Learn’ programming
button once, the red LED
should light up. You are now
in programming mode.
Press and release button 1
on your new remote once. If programming is successful, the red LED will turn off.
Replace the cover and test
your new remote at the unit to
conrm.
Locate the receiver board on
the internal circuit board.
1 2
6 7 8
3 4
5
Reach under the bottom to
release the locking clip. Lift the cover off to reveal the internal circuit board.
Identify your receiver unit.
Caution: Do not touch any other buttons or components other than what is stated to do so in the below procedure.

RCG01A 31A RCG01A
RCG01A - GARAGE & GATE
REMOTE PROGRAMMING
The following procedure is for programming a RCG01A remote to your garage sectional door:
On the right side of the circuit
board locate the reciever board.
On the receiver board locate
the ‘S1’ or ‘Learn’ programming
button. It will be situated next to
a red LED.
Press and release the
‘S1’ or ‘Learn’ programming
button once, the red LED
should light up. You are now
in programming mode.
Press and release button 1
on your new remote once. If programming is successful, the red LED will turn off.
Replace the cover and test
your newv remote at the unit to
conrm.
1 2 4
5 6
3
Unclip the light cover and
remove it.
Identify your receiver unit.
Caution: Do not touch any other buttons or components other than what is stated to do so in the below procedure.