Indesit DWL 700 User manual

Operating Instructions – Dishwasher Indesit DWL 700
Control Panel
A) On/Off button
B) On/Off light
C) Handle for opening door
D) Dial for selecting cycles
E) Low salt indicator light
F) Low rinse aid indicator light
G) Cycle phase and delayed start indicator lights
H) Delayed start select button
I) ½ load button
L) ½ load indicator light
R) Start/Reset button
Programmes

Cycle phase indicator lights
The dishwasher is provided with 4 indicator lights “G” which come on in sequence as the appliance is performing that
specific phase of the wash cycle. These phases are:
Operating the dishwasher
•Load the dishwasher
•Check that the upper and lower arms can rotate freely
•Add the detergent and close the door.
•Press the On/Off button “A”. You will hear a short beep and indicator light “B” lights up. At this point the
appliance is on and ready to be programmed.
•Turn the cycle selector dial “D” clockwise until the reference notch on the dial corresponds with the number or
symbol for the cycle you wish to set.
•If the appliance door is shut, press the Start button “R” and you will hear a beep, the cycle will start up within a
few seconds.

Warning! Do not open the dishwasher door whilst the appliance is in operation.
Unloading the dishwasher
Care must be taken when opening the door as hot steam will escape. Please allow 15-30 minutes before unloading
the dishwasher so the dishes can cool. Unload the lower rack first, then the upper rack.