Indiana Paddle & Surf FOIL User manual

www.indiana-paddlesurf.com
1) Make sure to coat all screws with a thin
layer of Tef-Gel before assembly. This will
prevent corrosion and seizing of the screws.
2) Check your screws before every session
and make sure they are tight.
3) Rinse your foil with fresh water after every use.
4) Check the anodes in the mastplate and the
cartridge regularly. They will degrade after some
time. This is normal. This will happen faster
when the foil is used in salt water. Replace the
anodes if they are broken or cracked.
3) Make sure there is no sand or dirt on the
screws or thread-holes. If there is sand on
the screws you may damage the threads in
the mast.
4) If the frontwing is stuck, or is difficult to
slide onto the fuselage, use a hard rubber
mallet (not included) to loosen the front
wing by hitting the trailing edge near the
center of the wing.
5) We recommend that you take apart the
foil completely if you are not using it for a
long time.
1) Make sure to coat all screws with a thin layer
of Tef-Gel before assembly. This will prevent
corrosion and seizing of the screws.
2) Check your screws before every session and
make sure they are tight.
3) Rinse your foil with fresh water after every use.
4) Check the anodes in the mastplate and the
cartridge regularly. They will degrade after some
time. This is normal. This will happen faster
when the foil is used in salt water. Replace the
anodes if they are broken or cracked.
3) Make sure there is no sand or dirt on the
screws or thread-holes. If there is sand on the
screws you may damage the threads in the mast.
4) If the frontwing is stuck, or is difficult to slide
onto the fuselage, use a hard rubber mallet (not
included) to loosen the front wing by hitting
the trailing edge near the center of the wing.
5) We recommend that you take apart the foil
completely if you are not using it for a long time.
6) DO NOT insert the Tuttle Head into your
board without the Mast and Plate securely
attched witht the screw as it will be difficult
to remove.
INDIANA FOIL – Quick Start Guide
INDIANA WINDFOIL – Quick Start Guide
M8 40mm
M8 60mm
M8 60mm
M8 Button Head 40mm
M8 30mm
M8 30mm
Plate
Mast
Mast
Anode
Anode
Cartridge
Cartridge
M8 25mm
M8 25mm
Stabilizer
Stabilizer
Tuttle Head
Angle Adapter
Angle Adapter
Plate
Slide Wing onto Fuselage
Slide Wing onto Fuselage
Front Wing
Front Wing
Fuselage
Fuselage
NEW MANUAL

You can choose between three stabilizer positions and
angles on your fuselage. The recommended angle adapter
is 2 degree. This will give you a nice and balanced feel.
If you would like to have a very loose and fast feel, use the 1
degree adapter.
Have fun experimenting and finding the perfect setup that
works best for you.
STABS
370
420
550
MASTS
50 cm
75 cm
90 cm
105 cm
FUSELAGES
Surf
Wind
FRONTWINGS
1100P
Pumping and Carving
Pumping
Lightwind, Beginners
Beginners Wind, Surf Foil
Dockstart, Intermediate
Surf, Wing and Windfoil
Wing and Windfoil
Light Wind
Advanced Wing
and Windfoil
Pumping, Surf,
Wakefoil, Wingfoil
Windfoil
1150DWR
Downwind Race
Downwind Race
Windfoil, Wingfoil
Lightwind Freeride
Beginners Wind,
Surf Foil
Intermediate Surf,
Wing and Windfoil
Downwind,
Windfoil Light Wind
Advanced Wing
and Windfoil
Downwind, Wakefoil,
Wingfoil
Windfoil
920H-AR
Pumping, Carving,
Jumping, Kitefoil
Pumping
Not recommended
Not recommended
Intermediate Surf,
Windfoil and Wingfoil
Downwind, Windfoil
advanced Wingfoil, Kitefoil
Advanced Wing, Kite
and Windfoil
Pumping, Surf,
Wakefoil, Wingfoil
Windfoil
820P
Pumping, Carving,
Jumping, Kitefoil
Pumping
Not recommended
Not recommended
Intermediate Surf,
Windfoil and Wingfoil
Downwind, Windfoil,
advanced Wingfoil, Kitefoil
Advanced Wing, Kite
and Windfoil
Pumping, Surf,
Wakefoil, Wingfoil
Windfoil
850S
Large Waves,
Kitefoil
Good Waves,
Lightwind Kitefoil
Not recommended
Beginners Kitefoil
Advanced Surf Foil
Windfoil Freeride,
Kitefoil Lightwind
Advanced Wing,
Kite and Windfoil
Surf, Wakefoil,
Wingfoil, Kitefoil
Windfoil
620K
Kitefoil
Kitefoil
Beginner Kitefoil
Beginners Kitefoil
Expert Surf Foil,
Wave Kitefoil
Kitefoil advanced
Advanced Wing,
Kite and Windfoil
Kitefoil, Wingfoil
Windfoil
INDIANA FOIL – Fuselage length and stabilizer angle trim
INDIANA FOIL – Combination Guide
SHORT Fuselage Length STANDARD Fuselage Length LONG Fuselage Length
Maximum looseness
Highest turning speed
Best pump performance
A good balance between
stability and performance
Maximum pitch resistance
Highest stability
Maximum yaw resistance
www.indiana-paddlesurf.com