iNels AirGateway User manual

Strana 1z 9
AirGateway
Návod / rev.0

Strana 2z 9
AirGateway
Návod / rev.0
1. Introduction .................................................................................................................... 3
2. Setting AirGateway a station (client) to connect to your WiFi network ............................ 4
3. Settings.......................................................................................................................... 5

Strana 3z 9
AirGateway
Návod / rev.0
1. Introduction
Congratulations on purchasing the AirGateway (WIfi bridge).
AirGateway is connected to the output jack RJ45 PoE power adapter.
AirGateway unit can be combined with PoE power adapter for easier installation of LARA,
because it is no longer necessary to resolve the supply of the Internet router or switch.
AirGateway will take care of the access to the Internet
Before you begin
The instruction manual provides information on installing and operating the device. The instruction
manual is always a part of the supply. Only perform installation after becoming thoroughly familiar with
this User Guide and device functions. Problem-free function of the device also depends on the way it
was shipped, stored and handled. If you notice any signs of damage, deformation, malfunction or a
missing part, do not install this product and return it to the point of sale. At the end of its service life,
the product and its parts must be treated as electronic waste. Before starting the installation, make
sure that all wires and connected parts are not under voltage. When assembling and performing
maintenance, you must uphold safety regulations, standards, directives and special provisions for
working with electrical equipment.

Strana 4z 9
AirGateway
Návod / rev.0
2. Setting AirGateway a station (client) to connect to your WiFi
network
Before the first configuration is recommended to reset the device to the factory settings (factory
default).
Connect the device to the power supply.
On the underside of the module, press the reset button for > 10s with a thin non-metallic
object
On top of the module the color of the LED changes.
Disconnect the AirGateway from the power supply.
Connect AirGateway to the power supply.
Connect AirGateway to your PC
Wireless connection: connect using the SSID - www.ubnt.com (no password), in your
browser enter the AirGateway IP address 192.168.1.1 and confirm.
Cable: PC permanently, set the IP address in the same range as the AirGateway (eg .:
192.168.1.2) using an Ethernet cable to connect to AirGateway.
The startup screen. Fill your login information:
- Username (username): ubnt
- Password (Password): ubnt
- Country / Language: Select your choice
Check approval and confirm Login.

Strana 5z 9
AirGateway
Návod / rev.0
3. Settings
Uncheck Quick Setup (Quick Setup Wizard), click Cancel.
The initial setup screen, AirGateway.

Strana 6z 9
AirGateway
Návod / rev.0
Open the NETWORK tab and set:
Network Mode: Bridge
Configuration: Advanced
Managment Interface: BRIDGE0
Managment IP Adress: select DHCP
DHCP Falback IP: enter the IP address of the gateway router to which you want to connect
AirGateway
DHCP Falback NetMask: enter the subnet mask (in most cases 255.255.255.0)
Save the settings Change.
Note.: After saving settings you may disconnect the AirGatewa from the PC. Reconnect and continue the setup.

Strana 7z 9
AirGateway
Návod / rev.0
Open the Wireless tab and set:
Configuration Mode: Advanced
Wireless Mode: Station
WDS (Transparent Bridge Mode): must not be checked
SSID: Select the WiFi network to which you want to connect
(If you have more WiFi routers with the same network name (WDS), you need to determine
which WiFi router will be set for theAirGateway to connect to. In the menu select the desired
network and click Lock to AP save the MAC address. AirGateway will connect through the
selected nearest WiFi router)
WPA Preshared Key: enter the password of the WiFi router to which you want to connect your
AirGateway
Save the settings Change.

Strana 8z 9
AirGateway
Návod / rev.0
Setting confirmed by pressing Apply.
AirGateway connects to the WiFi router and will be assigned an IP address to a DHCP server
on your WiFi router.
Note.: If you later want to change the settings, locate your AirGateway by MAC address in the settings of
your router.
Disconnect AirGateway from PC (if wired), and by disconnecting the / connecting the power
your AirGateway will restart.
Use an Ethernet cable to connect to AirGateway to LARA Radio and LARA Intercom.
Connection examples:
Power supply PoE + WiFi into a box

Strana 9z 9
AirGateway
Návod / rev.0
Power supply PoE + WiFi