Infinea X User manual
Choose 2Rent
Phone 1 (800) 622-6484
Fax 1 (866) 937-8254
info@choose2rent.com
www.choose2rent.com
page 1 of 3
Top Side
1. Front Speaker
2. iOS ON/OFF Button
3. Scan Button
4. Status LED
5. Speaker Toggle Button
6. Microphone
7. Home Button
8. Battery Status Button
9. Volume Buttons
How to Operate your
Equipment
Bottom Side
1. iOS Camera Opening
2. Barcode Scanner
3. RFID Antenna
4. Battery Pack
5. Battery Latch
6. Reaer Speaker
page 2 of 3
Power On
When the Infinea X is in the off mode, pressing the scan button
momentarily or the Home Button turns on the unit.
Pressing the scan button a second time will activate the scanner for
normal bar code scanning.
How to Scan
To scan a barcode, first activate the Infinea X by pressing the scan
button. Then position the scan head as close to the barcode label as
possible so that the scan line crosses both the ends of the barcode (or)
is within the width of the red illuminated box. Slowly pull back away
until the barcode has been read by the scanner as shown in the figure
below.
page 3 of 3
How to Charge Infinea X
1. Connect mini USB charger cable as shown.
2. Determine the charge state by viewing the status
LEDs.
Please call our support team if you need assistance
setting up your rental devices
1(800) 622-6484
Battery LED Status
One LED blinks red/emergency low battery = 9% - 1%
LEDs blink red = 24% - 10%
LEDs blink orange = 49% - 25%
LEDs blink green = 74% - 50%
LEDs solid green = 100% - 75%
