infobit iSpeaker MD30 User manual
INFOBIT www.infobitav.com info@infobitav.com
iSpeaker MD30 Quick Guide
Thank you for choosing this device. The following
guidelines will give you a quick overview of how to use
this product.
Cautions
To ensure reliable use of the equipment and the safety of
personnel, please observe this guide during installation,
use and maintenance.
1. When install the equipment, make sure the power
cord and the chassis are well grounded.
2. Keep the working environment well ventilated, so that
the heat generated by the equipment can be
discharged in time to avoid high temperature and
damage to the equipment.
3. In a humid and dewy environment or when not in use
for a long time, the main power supply should be
turned off.
4. Be sure to unplug the AC power cord from the power
supply outlet before the following operations.
-Remove or reassemble any part of the equipment.
-Disconnect or reconnect any electrical plugs or
connections to the equipment.
5. Do not disassemble the equipment without
permission from non-professionals to avoid the risk of
electric shock. Do not repair the equipment privately
to avoid aggravating the degree of damage.
6. Do not spill any corrosive chemicals or liquids on or
near the equipment.
Equipment information
The iSpeaker MD30 is a DANTE (AES67) interface
microphone that enables the conversion of analog audio
signals to digital audio signals for long-distance
transmission via the DANTE interface. The microphone is
powered via POE (IEEE 802.03af).
①Dante interface with POE function
POE power and DANTE audio output
②Pushbutton Switches
Turning the microphone on or off
③Gooseneck Microphone
For sound pickup
④Volume adjustment knob (at bottom)
Adjustable range: 0dB-23dB
2. Equipment parameters
Components
Electret condenser microphone core
Sensitivity
-40dBV /Pa
Directionality
Heart-shaped single pointing
Frequency
Response
20Hz-20KHz
Output
Impedance
280 Ohm
Maximum sound
pressure
140dB, THD<1%
Signal-to-noise
ratio
>92dB
Power supply
method
11-52v phantom power, 2mA
POE powered IEEE802.3af/at/bt
Input Connector
4-pin airline plug male connector
Output
Connector
4-pin male XLR connector
Size
Microphone pole: 388.7mm
Base: 134.6x100x58.2mm
INFOBIT www.infobitav.com info@infobitav.com
3. Equipment size
4. Equipment operation
①Connect the device correctly
②Control DANTE audio routing with Dante Controller
③Turn the microphone on or off with the
microphone switch
Packaging Details
iSpeaker MD30
Quick Guide
1 pcs
1 pcs
Warranty Card
Date of shipment.
Product Model.
Fuselage no.
Distribution
