INFRALAN ILK-IDPC User manual

0
Dual-Lens People Counting Camera
Quick Start Guide

Dual-Lens People Counting Camera·Quick Start Guide
1
About this Manual
This manual is applicable to Dual-Lens People Counting Network
Camera.
The Manual includes instructions for using and managing the
product. Pictures, charts, images and all other information
hereinafter are for description and explanation only. The information
contained in the manual is subject to change, without notice, due to
firmware updates or other reasons. Please find the latest version in
the company website
Please use this user manual under the guidance of professionals.
Legal Disclaimer
REGARDING TO THE PRODUCT WITH INTERNET ACCESS, THE USE OF
PRODUCT SHALL BE WHOLLY AT YOUR OWN RISKS. OUR COMPANY
SHALL NOT TAKE ANY RESPONSIBILITES FOR ABNORMAL OPERATION,
PRIVACY LEAKAGE OR OTHER DAMAGES RESULTING FROM CYBER
ATTACK, HACKER ATTACK, VIRUS INSPECTION, OR OTHER INTERNET
SECURITY RISKS; HOWEVER, OUR COMPANY WILL PROVIDE TIMELY
TECHNICAL SUPPORT IF REQUIRED.
SURVEILLANCE LAWS VARY BY JURISDICTION. PLEASE CHECK ALL
RELEVANT LAWS IN YOUR JURISDICTION BEFORE USING THIS
PRODUCT IN ORDER TO ENSURE THAT YOUR USE CONFORMS THE
APPLICABLE LAW. OUR COMPANY SHALL NOT BE LIABLE IN THE
EVENT THAT THIS PRODUCT IS USED WITH ILLEGITIMATE PURPOSES.
IN THE EVENT OF ANY CONFLICTS BETWEEN THIS MANUAL AND THE
APPLICABLE LAW, THE LATER PREVAILS.
Regulatory Information
FCC Information

Dual-Lens People Counting Camera·Quick Start Guide
2
Please take attention that changes or modification not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
FCC compliance: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.

Dual-Lens People Counting Camera·Quick Start Guide
3
EU Conformity Statement
This product and - if applicable - the supplied
accessories too are marked with "CE" and comply
therefore with the applicable harmonized European
standards listed under the EMC Directive 2014/30/EU, the RoHS
Directive 2011/65/EU.
2012/19/EU (WEEE directive): Products marked with
this symbol cannot be disposed of as unsorted
municipal waste in the European Union. For proper
recycling, return this product to your local supplier
upon the purchase of equivalent new equipment, or dispose of it at
designated collection points. For more information see:
www.recyclethis.info
2006/66/EC (battery directive): This product contains
a battery that cannot be disposed of as unsorted
municipal waste in the European Union. See the
product documentation for specific battery
information. The battery is marked with this symbol,
which may include lettering to indicate cadmium (Cd), lead (Pb), or
mercury (Hg). For proper recycling, return the battery to your supplier
or to a designated collection point. For more information see:
www.recyclethis.info
Industry Canada ICES-003 Compliance
This device meets the CAN ICES-3 (B)/NMB-3(B) standards
requirements.
Safety Instruction

Dual-Lens People Counting Camera·Quick Start Guide
4
These instructions are intended to ensure that user can use the
product correctly to avoid danger or property loss.
The precaution measure is divided into “Warnings” and “Cautions”
Warnings: Serious injury or death may occur if any of the warnings
are neglected.
Cautions: Injury or equipment damage may occur if any of the
cautions are neglected.
Warnings
●Proper configuration of all passwords and other security settings
is the responsibility of the installer and/or end-user.
●In the use of the product, you must be in strict compliance with
the electrical safety regulations of the nation and region. Please
refer to technical specifications for detailed information.
●Input voltage should meet both the SELV (Safety Extra Low
Voltage) and the Limited Power Source with 12 VDC according to
Warnings Follow these
safeguards to prevent
serious injury or death.
Cautions Follow these
precautions to prevent
potential injury or material
damage.

Dual-Lens People Counting Camera·Quick Start Guide
5
the IEC60950-1 standard. Please refer to technical specifications
for detailed information.
●Do not connect several devices to one power adapter as adapter
overload may cause over-heating or a fire hazard.
●Please make sure that the plug is firmly connected to the power
socket. When the product is mounted on wall or ceiling, the
device shall be firmly fixed.
●If smoke, odor or noise rise from the device, turn off the power
at once and unplug the power cable, and then please contact
the service center.
Cautions
●Make sure the power supply voltage is correct before using the
camera.
●Do not drop the camera or subject it to physical shock.
●Do not touch sensor modules with fingers. If cleaning is
necessary, use clean cloth with a bit of ethanol and wipe it
gently. If the camera will not be used for an extended period,
please replace the lens cap to protect the sensor from dirt.
●Do not aim the camera at the sun or extra bright places.
Blooming or smearing may occur otherwise (which is not a
malfunction), and affect the endurance of sensor at the same
time.
●The sensor may be burned out by a laser beam, so when any
laser equipment is in using, make sure that the surface of sensor
will not be exposed to the laser beam.

Dual-Lens People Counting Camera·Quick Start Guide
6
●Do not place the camera in extremely hot, cold (the operating
temperature shall be -10°C to +40°C for indoor cameras, and -
30°C to +60°C for outdoor and mobile cameras), dusty or damp
locations, and do not expose it to high electromagnetic
radiation.
●To avoid heat accumulation, good ventilation is required for
operating environment.
●Keep the camera away from liquid while in use.
●While in delivery, the camera shall be packed in its original
packing, or packing of the same texture.
●Regular part replacement: a few parts (e.g. electrolytic
capacitor) of the equipment shall be replaced regularly
according to their average enduring time. The average time
varies because of differences between operating environment
and using history, so regular checking is recommended for all the
users. Please contact with your dealer for more details.
●Improper use or replacement of the battery may result in hazard
of explosion. Replace with the same or equivalent type only.
Dispose of used batteries according to the instructions provided
by the battery manufacturer.
●If the product does not work properly, please contact your
dealer or the nearest service center. Never attempt to
disassemble the camera yourself. (We shall not assume any
responsibility for problems caused by unauthorized repair or
maintenance.)

Dual-Lens People Counting Camera·Quick Start Guide
7
Table of Contents
1 Appearance Description ................................................................. 8
Type I Camera for Indoor Scenario .................................. 8
Type II Camera for Outdoor Scenario ............................ 10
Type III Camera for Mobile Scenario.............................. 12
2 Installation.................................................................................... 15
Type I Camera Installation ............................................. 15
Type II Camera Installation ............................................ 20
Type III Camera Installation ........................................... 25
3 Setting the Network Camera over the LAN .................................. 31
Wiring ........................................................................... 31
Activating the Camera ................................................... 32
Activation via Web Browser................................ 32
Activation via IDM Software ............................... 33
Modifying the IP Address .............................................. 35
4 Accessing via Web Browser .......................................................... 37
0504061070605

Dual-Lens People Counting Camera·Quick Start Guide
8
1Appearance Description
There are three types of dual-lens people counting camera for indoor,
outdoor and mobile scenarios.
Attention!
Disassembling the camera without professional technical instruction
may affect the accuracy of people counting function. Contact the
technical support for repair if any malfunction happens.
Type I Camera for Indoor Scenario
11
2 3
4 5 6 7
Overview of Type I Camera

Dual-Lens People Counting Camera·Quick Start Guide
9
Description of Type I Camera
No.
Description
1
Lens
2
Power
indicator
Solid red: running properly
Off: power supply abnormal
3
Status
indicator
Solid blue: running properly
Flashing red: network connection
abnormal
Flashing blue: other exceptions
4
Power supply interface (12 VDC)
5
RS-485 and alarm I/O interface
6
Network interface (support power over Ethernet)
7
Reset button
Note:
Press RESET for about 10s when the camera is powering on or
rebooting to restore the default settings, including the user name,
password, IP address, port No., etc.

Dual-Lens People Counting Camera·Quick Start Guide
10
Type II Camera for Outdoor Scenario
1
2
3
4
5
678 9
10 11 12
Overview of Type II Camera
Description of Type II Camera
No.
Description
1
IR
2
Lens
3
Camera body

Dual-Lens People Counting Camera·Quick Start Guide
11
No.
Description
4
Enclosure
5
Mounting base
6
RS-485
7
Power cord (12 VDC)
8
Alarm I/O
9
RJ45 Ethernet interface
10
Link
indicator
Flashing yellow: normal network
communication
Off: no network communication
11
Status
indicator
Solid green: working properly
Off when the people counting function
is in the following conditions: 1) off; 2)
abnormal shutdown; 3) abnormal
heartbeat.
12
Power
indicator
Solid red: working properly
Off: power supply abnormal

Dual-Lens People Counting Camera·Quick Start Guide
12
Type III Camera for Mobile Scenario
This camera type has different cable groups for different models. The
following figure shows both cable groups.
1
2
3
4
5
678
910 11
12131415
Overview of Type III Camera
Description of Type III Camera
No.
Description
1
IR
2
Lens

Dual-Lens People Counting Camera·Quick Start Guide
13
No.
Description
3
Camera body
4
Enclosure
5
Mounting base
6
Link
indicator
Flashing yellow: normal network
communication
Off: no network communication
7
Status
indicator
Solid green: working properly
Off when the people counting function
is in the following conditions: 1) off; 2)
abnormal shutdown; 3) abnormal
heartbeat.
8
Power
indicator
Solid red: working properly
Off: power supply abnormal
9
Alarm I/O, RS-485
10
Power cord (12 VDC)
11
M12 aviation plug
12
RS-485
13
Power cord (12 VDC)
14
Alarm I/O
15
RJ45 Ethernet interface

Dual-Lens People Counting Camera·Quick Start Guide
14
Note:
●One camera has one cable group.
●The relation between RJ45 wire and M12 wire is shown in the
following figure and table.
1 2
3
4
1
8
M12 Aviation Plug RJ45 Network Interface
Figure 1-4 RJ45 Interface and M12 Aviation Plug
Wire Relation
M12 Wire
RJ45 Wire
TX+
1
1
TX-
3
2
RX+
2
3
RX-
4
6

Dual-Lens People Counting Camera·Quick Start Guide
15
2Installation
Before you start:
●Make sure the device in the package is in good condition and all
the assembly parts are included.
●The standard power supply is 12 VDC, please make sure your
power supply matches with your camera.
●Make sure all the related equipment is power-off during the
installation.
●Check the specification of the products for the installation
environment.
●Make sure that the ceiling is strong enough to withstand four
times the weight of the camera and the bracket.
Type I Camera Installation
Steps:
Select a suitable mounting position.
The relations among focal length (for the focal length of your
camera, see the label on camera body), mounting height, and
maximum detection span are shown in the following table.

Dual-Lens People Counting Camera·Quick Start Guide
16
Installation Recommendation

Dual-Lens People Counting Camera·Quick Start Guide
17
Mounting Height
Ground
Max. Detection Span
Focal Length
(mm)
Mounting Height
(m)
Max. Detection Span
(m)
2.0
2.5
1.8
2.0
3.0
2.9
2.0
3.5
4.0
2.0
4.0
5.2
2.8
3.0
2.2
2.8
3.5
3.1
2.8
4.0
4.0
2.8
4.5
4.8
2.8
4.7
5.2
4.0
4.0
2.8
4.0
4.5
3.4
4.0
5.0
4.0
4.0
5.5
4.6
4.0
6.0
5.2
Notes:

Dual-Lens People Counting Camera·Quick Start Guide
18
●Mounting height of 2.0 mm lens camera should be no higher
than 4 meters, and 2.8 mm lens camera no higher than 4.8
meters.
●The camera must be installed on a flat surface parallel to the
ground (or, the optical axes of both lenses should be
perpendicular to the ground).
●It is recommended to install the camera at an entrance/exit,
where the detection area can be covered better.
Paste the drill template to the desired mounting place.
123.8
2-Φ4.5
Drill Template
Align the "Front" mark on drill template with that on mounting
base. Fix the mounting base with supplied screws.
Mounting
Base

Dual-Lens People Counting Camera·Quick Start Guide
19
Fix the Mounting Base
Align the "Front" mark on the mounting base with that on camera
bottom.
Fit the hooks on mounting base in the big end of the slots on
camera bottom. Push to get the camera clasped.
Hook Hook
Slot
Slot
Clasp
Install the Camera