INOLAV IB1001 Series User manual

A
Measuring
tape
Power drill
Phillips
screwdriver
Pencil
29 1/2"
Recommened
C
B
B
Hanging system
Adjusts height of vanity
D
INSTALLATION INSTRUCTIONS
A
x 1 Adams cabinet
B
x 2 Wall bracket
Re-enforce the wall using a sheet of
plywood or 2" by 6"wood beams.
1 2
Measuring for the desired height,
secure wall brackets (B) to the wall.
Make sure that screws go into the
re-enforced area of the wall. 29.5" to
the top screw is the recommended
height.
3
Remove drawer from ADAMS cabinet
(A). See drawer removal below.
4
Hang cabinet (A) onto wall brackets (B) and adjust
hanging system as shown below.
Secure cabinet (A) to the wall using long screws (D). Make
sure to drive screws (B) into re-enforced area of the wall.
5
C
x 6
Medium
size
screw
TOOLS REQUIRED
Finished view
D
x 2
Long
size
screw
D
x 8
Anchors
(Discard
anchors for
installation in
the USA. Use
wood re-
enforced walls
instead.)
Adjusts distance
to wall

Finished view
Pre-drill holes
3/8" dia
drill bit
A
A
Vanity
Front of
cabinet
Front of cabinet
C
Screw cap
B
Threaded rod
C
Screw cap
Emmet vanity
Emmet vanity
A
Emmet Bridge
Measuring
tape
Power drill
3/8" dia drill bit
Phillips
screwdriver
Pencil
C
Screw cap
B
Threaded rod
C
Screw cap
Phillips
screwdriver
INSTALLATION INSTRUCTIONS
A
x 1
Emmet 11 Bridge
IC4011-
B
x 8 Threaded
rod
Remove drawer from EMMET vanity.
See drawer removal below. (EMMET
vanity sold separately.)
1 2
Finish drilling the pre-drilled holes in
EMMET vanity. Make sure to drill only
the side that will connect to EMMET
bridge.
3
Remove drawer from EMMET bridge
(A). See drawer removal below.
4
Attach EMMET bridge (A) to vanity by screwing the threaded
rod (B) into screw cap (C) as shown below. Use a phillips
screwdriver to tighten the screw caps.
Repeat step 1 and 2 using second vanity. Attach second
vanity to the other side of EMMET bridge (A) by repeating
step 4.
5
C
x 16 Screw cap
TOOLS REQUIRED

Apply stone adhesive here
Wing nut
Spring washer
Flat washer
L Bracket
Threaded rod
Finished view
Model No:
IB1001-XX, IT20XX-XX
Prepare counter top for installation by placing it upside down 1.
on a smooth surface.
Place undermount basin in the final position and make a mark 2.
sround it using a marker.
Apply stone adhesive (liquid nail or similar) on the top edge of 3.
basin. See fig 1.
Attach basin to counter top using the threaded rods, L 4.
brackets, flat washers, spring washers, and wing nuts as
shown in fig 1. Do not fully tight the wing nut at this step.
Use previous marking to align baisn in the final position 5.
Thighten wing nut and let adhesive dry. 6.
If neccesary, apply caulking in the inside of basin where it 7.
meets with the counter top.
Install counter top onto cabinet using silicone or similar 8.
adhesive. Check your alignments before allowing the adhesive
to dry.
Figure #1