modway EEI-2136 User manual

EEI-2136 CHAIR
Thank you for purchasing the MODWAY CHAIR!
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by step instructions.
2. Owing to the size and weight of the sofa, we recommend that it is assembled by two adults on a carpeted or
padded area, in the room that it is intended for. Approximate time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
component from time to time, so please save the tools that have been provided.
6. Please keep all pieces out of reach of children.
Hardware:
A Bolt (M6*H10mm)x16
B Allen Wrench x1
Components:
1. Seat Cushion x1 2. Chair Body x1 3. Leg x4
Customer Service 908-368-1025 I www.modwayfurniture.com Page 1 of 2

EEI-2136 CHAIR
STEP 1:
Please put the Chair Body (2) upside down on a carpeted or padded area. Open the Zipper on the bottom of
Chair Body (2) as shown, take out the packages of 4 pieces of Legs (3), then close the Zipper on the bottom of
Chair Body (2) .
Attach 1 piece of Leg (3) into the bottom of Chair Body (2) by using 4 pieces of Bolts (A) through the holes
on the bottom of Chair Body (2), Use Allen Wrench (B) to tighten the Bolts (A) clockwise until secure.
Repeat the same steps for the other 3 pieces of Legs (3).
STEP 2:
Carefully turn over the Chair Body (2), tear off the Protect film attached onto the Velcro at first. Then place the
Seat Cushion (1) to the assembled Chair Body (2) as shown. Attach them by using Velcro.
Assembly is complete.The Chair is ready to enjoy now!
Customer Service 908-368-1025 I www.modwayfurniture.com Page 2 of 2
x 4PCS
Legs inside