Insignia NS-B4111 - CD Boombox With AM/FM Tuner User manual

Front IMPORTANT SAFETY INSTRUCTIONS
1 Read these instructions.
2 Keep these instructions.
3 Heed all warnings.
4 Follow all instructions.
5 Do not use this apparatus near water.
6 Clean only with dry cloth.
7 Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8 Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including
ampliers) that produce heat.
9 Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with
one wider than the other. A grounding type plug has two blades and a third grounding prong.The wide blade or
the third prong are provided for your safety. If the provided plug does not t into your outlet, consult an electrician
for replacement of the obsolete outlet.
10 Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
11 Only use attachments/accessories specied by the manufacturer.
12 Use only with the cart, stand, tripod, bracket, or table specied by the manufacturer, or
sold with the apparatus.When a cart is used, use caution when moving the cart/apparatus
combination to avoid injury from tip-over.
13 Unplug this apparatus during lightning storms or when unused for long periods of time.
14 Refer all servicing to qualied service personnel. Servicing is required when the apparatus
has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or
has been dropped.
15 Ventilation: Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the
product and to protect it from overheating, and these openings must not be blocked or covered.The openings
should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This product should not
be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the
manufacturer’s instructions have been adhered to.
16 The power plug is used as the disconnect device and should remain readily accessible during the device’s intended use.
To completely disconnect the device from power, you should disconnect the power plug from the AC power outlet.
17 The battery should not be exposed to excessive heat, such as direct sunlight, re, or the like.
18 Cautions and other markings are located at the bottom of the apparatus.
19 The marking information is located at the bottom of apparatus.
20 No naked ame sources, such as lighted candles, should be placed on the apparatus.
Caution: The use of any controls, adjustments, or procedures other than those specied herein may result in hazardous
radiation exposure.
Safety information
Warning: To reduce the risk of re or electric shock, do not expose this
appliance to rain or moisture.
This apparatus shall not be exposed to dripping or splashing, and no objects
lled with liquids, such as vases, shall be placed on the apparatus.
Flat size (W×H): 297 × 210 mm.
Final folded size: 99 × 210 mm.
Quick Setup Guide |NS-B4111
CD Boombox
PACKAGE CONTENTS
• CD boombox
• AC power cord
• Quick Setup Guide
FEATURES
Top
Back
Before using your new product, please read these instructions to prevent any damage.
1Handle
2CD door
3 Volume control
4FM antenna
5CD door open
1AUX IN jack
2Battery compartment
3Headphone jack
4AC input
The lightning ash with arrowhead
symbol, within an equilateral triangle,
is intended to alert the user to the
presence of uninsulated“dangerous
voltage”within the product’s
enclosure that may be of sucient
magnitude to constitute a risk of
electric shock to people.
The exclamation point within an
equilateral triangle is intended to
alert the user to the presence of
important operating and
maintenance (servicing) instructions
in the literature accompanying the
appliance.
WARNING: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE
PERSONNEL.
Class II equipment symbol
This symbol indicates that the unit has
a double insulation system.
# Item
1
2
3
4LCD screen
5
6LED
7
8
9REPEAT
10 PROG/MEM
11 SOURCE
12
13 Speakers
CD Function
Pause/Play
Previous
Next
Displays source and audio information
Rewind
Lights red when in Standby mode
Fast-forward
Stop
Repeat
Program
Source
Standby/On
Plays audio from your boombox
AM/FM Function
Auto scan
Previous
Next
Tune down
Tune up
N/A
N/A
Station storage
Source
Standby/On
REPEAT SOURCE PROG/MEM
CAUTION
RISK OF ELECTRIC
SHOCK DO NO OPEN
NS-B4111_15-0548_QSG_V6_EN.ai 1 6/23/2015 12:20:44 PMNS-B4111_15-0548_QSG_V6_EN.ai 1 6/23/2015 12:20:44 PM

SETTING UP YOUR CD PLAYER
Connecting AC power
Note: Batteries are not needed when connecting to AC power.
1Connect the AC power cord (included) to the AC input socket on the
CD player.
2Plug the cord into a standard AC wall out.
Installing batteries
1Insert eight C alkaline batteries (not included) into the battery
compartment as indicated on the diagram in the compartment.
2Securely close the battery compartment cover.
Notes:
• Battery power is used only when AC power is disconnected.
• Replace all batteries at the same time with the same battery type. Do not mix
battery types.
• When the CD player is stored unused for a long time, remove the batteries to
prevent damage.
USING YOUR CD PLAYER
Warning: Use of any controls, adjustments, or procedures other than those
specied may result in hazardous radiation exposure.
Using the FM/AM Radio
1 Press SOURCE repeatedly to select the FM/AM function. “FM/AM”
appears in the upper-right of the LCD screen.
2Find the station you want to listen to:
• Press / repeatedly to tune to a station manually.
• Press / to select saved (preset) stations.
Note: To save the current station to memory. Press PROG/MEM, then
press / to select a preset number you want to save, and then
press PROG/MEM again to complete the process. If you press PROG/MEM
after three seconds without pressing PROG/MEM again, station storage
mode is cancelled.
• Press and hold for two seconds to automatically scan and
store stations. Each station found during the scan will be saved to
memory from the lowest to the highest frequencies.
• For optimum FM reception, make sure that the FM (telescopic)
antenna is fully extended and vertical.
• For optimum AM reception, rotate the CD player to orient its
built-in antenna until you get the strongest signal.
Using the CD player
The CD player can play standard audio CDs and audio CDs created on
a computer’s CD-R/CD-RW drive.
1 Push SOURCE to select CD function. appears on the LCD
screen.
2Lift the CD door and insert a CD with the label facing up. Mount the
CD on the spindle and push down to lock it in place.
3Close the CD door. After a few seconds, the display shows the total
number of tracks on the CD. If the disc is not correctly inserted or is
defective, the display shows .
Playback begins automatically.
V6 ENGLISH 15-0548
Controlling CD playback
Listening to an external audio source
1Connect the external audio device to the AUX IN jack on the back
panel of your CD player using a 3.5 mm cable (not included).
2Press SOURCE to select the AUX function. “AUX”appears in the
upper-right of the LCD screen.
3Start playing music from your external audio device. Audio plays
through your CD player’s speakers.
4Use your external audio source to control playback.
Note: Make sure your audio device is not muted and the volume is turned up
to an adequate level.
MAINTAINING YOUR CDS
• Handle CDs only by their edges. Never allow your ngers to contact
the reective, unprinted side of the CD.
• Do not attach things such as adhesive tape and stickers to your audio
CDs.
• Periodically clean your CDs with a soft, lint-free, dry cloth.
Never use detergents or adhesive cleaners to clean the disc.
If necessary, use a CD cleaning kit.
• If the CD skips or gets stuck on a section of the disc, it is probably dirty
or damaged (scratched).
• When cleaning CDs, wipe in straight lines from the center of the CD to
the outside edge. Never wipe in circular motions.
SPECIFICATIONS
LEGAL NOTICES
FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation of this product is subject to
the following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply within the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced technician for help.
FCC warning
Changes or modications not expressly approved by the party responsible for compliance
with the FCC Rules could void the user’s authority to operate this equipment.
ONE-YEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA
For customer service, call 1-877-467-4289 (U.S. and Canada) or
01-800-926-3000 (Mexico)
www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its aliated companies.
Distributed by Best Buy Purchasing, LLC
©2015 Best Buy. All rights reserved.
Made in China
Dispose of batteries in the proper manner, according to federal, state, and local
regulations.
To play the CD
To pause playback
To stop playback
To skip tracks
To repeat tracks
To play tracks in
programmed order
Press . The current track number is shown on the display.
Press . The play indicator ashes on the display. Press again
to resume playback.
Press . The display shows the total number of tracks on the CD.
Press or .
Press REPEAT to repeat the current track. “1”appears in the
upper-right of the LCD screen. Press REPEAT twice to repeat the
entire disc (continuous play). appears in upper-right of the LCD
screen. Press REPEAT a third time to return to normal play.
1Press , then press PROG/MEM“prog”appears in the
upper-middle of the screen.“P01”(the track number in
programmed order) ashes for two seconds, followed by“01”
(Track number in the disc order). Press / to choose
another track, then press PROG/MEM again to conrm.“P02”
ashes for two seconds, followed by “01”. Repeat the operation
to conrm the second track in programmed order. After you have
selected the tracks you want, press to start playing in
programmed order.
2Press to stop playback. Press stop again to exit.“Prog”
disappears from the upper-middle of LCD screen.
Power
Radio frequency
coverage
GENERAL CD PLAYER
AC: AC120V ~ 60Hz 10W
Batteries: DC 12V (8 C batteries)
FM: 87.5~107.9 MHz
AM: 520~1710 KHz
Speaker: 2 × 8 ohms
Pick Up: 3-beam, semiconductor laser, 1-bit DA converter
Encoding: 8-time oversampling
CLASS1
LASER PRODUCT
NS-B4111_15-0548_QSG_V6_EN.ai 2 6/23/2015 12:20:50 PMNS-B4111_15-0548_QSG_V6_EN.ai 2 6/23/2015 12:20:50 PM