3
Insignia NS-DSC10A and NS-DSC10B 10 Megapixel Digital Cameras
www.insigniaproducts.com
LED and sound indicators
Your camera gives feedback to users in two ways:
•LEDIndicators
•Soundindicators
LED Indicators
Your camera is equipped with two LED indicators:
• An operation LED, located on the back of your 
camera. See “Back“on page 2 to locate the 
operation LED, 
• A self-timer LED, located on the front of the 
camera. See “Front“on page 1 to locate the 
Self-timer LED.
Sound indicators
Your camera is equipped with a buzzer to provide 
sound indicators.
Setting up your camera
Installing the batteries
To install the batteries:
1Make sure that your camera is turned off.
2Open the battery cover by sliding it in the 
direction indicated in the illustration.
3Insert two AA batteries into the battery 
compartment. Make sure that you match the + 
and – symbols on the batteries with the + and – 
symbols in the battery compartment.
4Close the battery cover.
5If you are replacing the batteries, go to the Setup 
menu and make sure the battery type selected 
matches the type of batteries you inserted in 
the camera. (See “Using the Setup and Tools 
menus” on page 13)
LED LED status Camera status
Operation
Off Power off
Green (steady) Power on, ready to take pictures, record, 
or playback.
Green (fast blink) Camera busy or deleting/copying/
recording/transferring data.
Green (slow blink) In Record mode, flash is charging, or AF 
error.
Self-timer
Off Self-timer off.
Amber (blinking)
Self-timer countdown is set. The LED 
blinks faster as the countdown reaches its 
end.
Sound indicator Camera status
One beep An operation, such as recording, has started. Also indicates using 
a menu and setting properties.
Two beeps An operation is complete.
Three beeps A low battery or other warning. Also indicates error messages, 
such as memory full or card error.
Continuous beep
When the self-timer is set, the camera beeps every second of the 
countdown between ten and four seconds left. It beeps every 
half second when the countdown reaches three seconds. The 
beep stops after the countdown completes.
Shutter sound The shutter is pressed to record an image.
Warning
Be sure to use only alkaline, NiMH, or lithium 
batteries with your camera. Failure to do so may 
damage your camera or cause risk of injury to 
yourself and others.
Notes
• A low battery indicator appears on the 
LCD when the batteries are nearly exhausted. 
Batteries should be replaced promptly when 
this indicator appears.
• Do not mix batteries of different types.
• Do not mix old and new batteries.
• Remove batteries when the charge is depleted.
• Battery chemicals can cause a rash. If the 
batteries leak, clean the battery compartment 
with a cloth. If chemicals touch your skin, wash 
immediately.
• If the camera is not going to be used for an 
extended period of time, remove the batteries.
• The camera body may feel warm to the touch 
after extended use. This is normal.
NS-DSC10A-10B_09-0323_MAN_V2.book Page 3 Monday, April 27, 2009 8:42 AM