2444-222 Rev. 5/17/2012 1:56 PM / See Owner’s Manual for Warranty Information.
Protected under U.S. and foreign patents (see www.insteon.com)
© Copyright 2012 INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845
11) If you are planning to manually link Micro Shutter to any INSTEON controllers, do so now (see Adding Micro
Shutter as an INSTEON Responder below).
12) Turn breaker off.
13) Place Micro Shutter in rear of wall box.
14) Remount switch in wall box.
15) Turn breaker back on.
Connected load will turn on at its previous state (prior to turning off breaker).
16) Test installation by tapping switch on and off.
Connected load will turn on and off.
17) Reinstall wallplate.
Adding Micro Shutter as an INSTEON Responder
We recommend using INSTEON SmartLinc and the free INSTEON iOS/Android smartphone and tablet app or home
automation software (such as HouseLinc) to add and monitor Micro Shutter on your home network. You can also add
Micro Shutter to your network manually by following the instructions below. Note: you must perform these steps
before reinstalling the wall switch.
1) Press and hold controller’s ON/scene button until it beeps.
Controller’s LED will start blinking green.
2) Adjust load connected to Micro Shutter to desired brightness level.
3) Press and hold Micro Shutter’s Set button until it double-beeps.
Controller will double-beep and its LED will stop blinking.
4) Test link by tapping controller’s ON/scene button on and off.
The load connected to Micro Shutter will turn on and off.
Adding Micro Shutter as an INSTEON Controller
We recommend using INSTEON SmartLinc and the free INSTEON iOS/Android smartphone and tablet app or home
automation software (such as HouseLinc) to add and monitor Micro Shutter on your home network. You can also add
Micro Shutter to your network manually by following the instructions below. Note: you must perform these steps
before reinstalling the wall switch.
1) Press and hold Micro Shutter’s Set button until it beeps.
Micro Shutter’s LED will start blinking green.
2) Adjust responder to desired state.
3) Press and hold responder’s Set button until it double-beeps.
Micro Shutter will double-beep and its LED will stop blinking.
4) Test link by tapping Micro Shutter’s paddle top and bottom to turn on/off.
The responder turn on and off.
FCC Compliance
This device complies with FCC Rules Part 15. Operation is subject to two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference that may be received or that may cause undesired
operation.
The digital circuitry of this device has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in residential installations. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio and television reception. However, there is no guarantee that interference
will not occur in a particular installation. If
