Intraphex TMN-NI11 User manual

TMN-NI11
Inniti Q50
Navigation Installation Manual

2
What’s In The Box
• RGB / GPS Interface
• CAN Interface
• CAN Connect T-Harness
• CAN to Interface Harness
• External Speaker
• GPS Antenna
• RCA Harness
• Momentary Switch
8GB SD Card With Intraphex Navigation
Software
• Install / Users Guides
This manual explains the installation and
wiring of the TMN-NI11 Navigation System /
Reverse Camera Interface.

3
POWER
GPS
DIP SWITCHES
SD CARD
MENU UP DOWN
TOUCH LVDS OUTPUT
CONTROL
SPK IN
SPK OUT
NAVI
TALKOVER
AUDIO
SWITCH
RGB
INPUT
VIDEO
INPUT
FACTORY
LOWER MONITOR
CAN BOX
YELLOW-V1
WHITE-V2
RED-REV. CAM
N/A
GPS SPKR
FACTORY LVDS
FROM VEHICLE
FACTORY 22PIN
POWER HARNESS
FROM VEHICLE
POWER/CAN T-HARNESS
LVDS T-HARNESS

4
Installation Instructions
Can Connect Harness:
Green – CAN generated +12 volt reverse signal (you can use this wire to
power your backup camera, max 1 amp)
Black – Ground (you can use this wire to ground your backup camera)
Yellow – Constant +12 volts
Red – CAN generated Accessory +12 volts
Grey – CAN generated data (dynamic parking grid lines)
White – CAN generated pulsed +12 volt wire (this wire will switch sources
when it sees a >+2.5 volt pulse)
DIP DOWN = ON UP = OFF
1RGB Input Enabled RGB Input Disabled
2Video 1 Input Enabled Video 1 Input Disabled
3Video 2 Input Enabled Video 2 Input Disabled
4Resolution 800x480 N/A
5Aftermarket Backup Camera
(Red RCA Input) OEM Camera
6N/A Normal Operation
7Normal Operation N/A
8N/A Normal Operation

5
DIP DOWN = ON UP = OFF
1RGB Input Enabled RGB Input Disabled
2Video 1 Input Enabled Video 1 Input Disabled
3Video 2 Input Enabled Video 2 Input Disabled
4Resolution 800x480 N/A
5Aftermarket Backup Camera
(Red RCA Input) OEM Camera
6N/A Normal Operation
7Normal Operation N/A
8N/A Normal Operation
Carefully disassemble the dash
of the vehicle. It’s advised that
you use masking tape and a plas-
tic pry-tool to avoid damage to
factory panels. Note: The factory
touchscreen is very sensitive. Be
very careful not to scratch it.
Gain access to the three plugs
on the lower monitor and unplug.
Set monitor assembly aside in
a safe location until it is time for
re-assembly.
Plug the provided Intraphex Pow-
er and LVDS T-harnesses into the
factory harnesses. Note: There
will be one extra factory harness
not used. You will simply re-install
this as factory when re-assem-
bling dash. See wiring diagram.

6
Make all connections to the
Intraphex Navigation interface.
Please see wiring diagram. Note:
Not all ports on interface will be
used.
Find a suitable location to mount
the Intraphex interface and
CAN box. Make sure to run your
antenna to desired location, and
choose how you are going to wire
your audio (see audio options)
Re-assemble the dash in the
reverse order you took it apart.
Note: before re-assembly, see the
“Audio Options,” “Finishing up,”
and “Screen Adjustment” sec-
tions. Be sure to test system fully
before nishing install.

7
AUDIO OPTIONS
Option 1:
Simply plug in the included Intraphex speaker
and install in a suitable location using the pro-
vided double-sided tape.
Option 2:
Cut the plug off of the included Intraphex speak-
er. Choose a speaker in the vehicle you would
like to use (a center channel or door speaker is
ususally most suitable). Looking at the speaker
plug, wire side, the top wires (clip side of plug)
are the inputs (coming from the radio), and the
bottom wires are the speaker outputs (to the
speaker). Speaker in +: RED Speaker in -: Black.
Speaker out +: Yellow Speaker out -: Black

8
FINISHING UP
SCREEN CALIBRATION
Before re-assembling the vehicle, you must cali-
brate the screen. To do this, simply turn the ve-
hicle on and allow the interface to start without
the SD card inserted. Press the factory “Menu”
button below the screen for 1 second to switch
into the interface source. It will change to a white
screen with a “crosshair” in the center. Use your
nger to give the crosshair a press. It will then
move to the upper left hand corner. Continue to
press this crosshair until you have completed all
four corners. Once nished, press the “OK” icon
that appears. At this point you can insert the Int-
raphex Navigation SD card into the interface and
press the navigation icon.
NAVIGATION SETUP
Once you have loaded the Intraphex Navigation
software, you will need to go through an initial
setup. The software is defaulted for the United
States, so you may simply hit next through the
entire process. All settings can be changed later
in the software’s settings menu.

9
SCREEN ADJUSTMENT
It is generally not needed, but you may ne tune
the screen to your liking. Located on the bottom
of the interface are the Menu/Up/Down buttons.
These buttons are recessed, so you will need
a pick-tool or small screwdriver to press them.
Once in the menu you can ne tune the pic-
ture, adjust alignment, etc. Note: Each setting is
unique to the source you are in. You can adjust
these settings independently: One setting for nav-
igation, one for Video 1, etc.

10
DEVICE OPERATION
To switch into the navigation source from the
factory screen, simply press the “Home” button
located directly below the factory monitor for 1
second. To switch back to the factory screen, just
give the Home button a short press. If you are
using additional video inputs, you will continue to
give the Home button 1 second presses. The sys-
tem will cycle through whatever inputs you have
turned on (see dipswitch settings).
Note: If you press and hold the Home button for
about 5 seconds, the monitor will turn off. This is
a factory function.

11
INTRAPHEX THREE YEAR LIMITED WARRANTY NONTRANSFERABLE
Terms of Limited Warranty INTRAPHEX warrants to the original retail purchaser, that the
product(s) purchased from an INTRAPHEX authorized dealer, in the original vehicle, are free
from defects in materials or workmanship under normal use and conditions for a period of
THREE (3) years from date of purchase. A sales receipt, showing the installation date and
INTRAPHEX product details are required to verify proof of purchase. Should the product(s) be
determined defective during the applicable warranty period, the defective product(s) will be
repaired or replaced with a reconditioned product(s), at INTRAPHEX’s sole option. To obtain
warranty service, the product(s) must be returned to an INTRAPHEX authorized installer along
with proof of warranty coverage.
Exclusions
- Elimination of externally generated static or noise
- Costs incurred for installation, removal or reinstallation of the product(s)
- Damage to any vehicle parts, accessories or vehicle electrical system.
- Cosmetic damage or damage due to negligence, misuse, abuse, failure to follow operating
instructions, accidental spills or customer applied cleaners
- Damage or loss due to environmental causes such as oods, airborne fallout, chemicals,
salt, hail, windstorms, lightning or extreme temperatures
- Damage or loss due to accidents, road hazards, re, theft or vandalism.
- Damage due to improper installation or connection, improper connection to equipment of
another manufacturer, modication of existing equipment
- Product(s) which have been opened or tampered with for any reason or which have been
damaged due to alteration or service performed by anyone other than INTRAPHEX
EXCEPT AS EXPRESSLY SET FORTH IN THIS LIMITED WARRANTY, INTRAPHEX MAKES NO
OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING ANY IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. INTRAPHEX EXPRESSLY
DISCLAIMS ALL WARRANTIES NOT STATED IN THIS LIMITED WARRANTY. ANY IMPLIED
WARRANTIES THAT MAY BE IMPOSED BY LAW ARE LIMITED TO THE TERMS OF THIS
EXPRESSED LIMITED WARRANTY.
Some states do not allow limitation on how long an implied warranty lasts. In such states, the
limitations or exclusions of this Limited Warranty may not apply. Some states do not allow the
exclusion or limitation of incidental or consequential damages. In such states, the exclusion
or limitation of this Limited Warranty may not apply to you. This Limited Warranty gives you
specic legal rights and you may have other rights, which vary from state to state.

Toll Free Tech Support: 888-228-5560
Local: 727-803-0324
Email: [e-mail]