Intraphex PMN-TY21 User manual

Pmn-TY21
INSTALLATION
MANUAL
ProdigY*MINI
navigation
INTEGRATION MODULE
This manual shows the install into a SINGLE RADIO TYPE.
vehicle disassembly will vary. wiring remains the same
with all vehicles.
See application guide for applicable vehicles

www.INTRAPHEX.com
SUPPOR[email protected]
SUPPORT: 810.355.2266
EXT 4
Fax: [phone]
Contacts

What’s In The Box
Contents
 VIDEO INTERFACE
 PRODIGY*MINI
 MAIN T-HARNESS
 MONITOR PCB
ASSEMBLY
 8GB SD CARD WITH
INTRAPHEX NAV
SOFTWARE
 INSTALL/USERS
GUIDES
 GPS ANTENNA
 MICROPHONE
 INTRAPHEX MOUSE

INTERFACE DIP SWITCH SETTINGS
DIP ON OFF
DIP 1 A/V 1 ON A/V 1 OFF
DIP 2 A/V 2 ON A/V 2 OFF
DIP 3 A/V 3 ON A/V 3 OFF
DIP 4 AFTERMARKET CAMERA OEM CAMERA
 DIP SWITCH SETTINGS MUST BE PERFORMED WITH UNIT POWERED OFF.
IT WILL NOT CAUSE DAMAGE, BUT THE FUNCTION WILL NOT BE
RECOGNIZED UNTIL POWER CYCLES.
A/V FUNCTIONS
 THIS UNIT SUPPORTS THREE AUDIO/VIDEO INPUTS. AND ONE
AUDIO/VIDEO OUTPUT.

RADIO CONTROL PANEL
BUTTON FUNCTIONS
 ONCE THE PMN-TY21 IS INSTALLED INTO THE RADIO YOU WILL ACCESS
THE NAVIGATION, A/V1,2,3 BY PRESSING AND HOLDING THE “AUDIO”
BUTTON FOR THREE SECONDS.

INTERFACE PARTS

 REMOVE MONITOR FROM VEHICLE AND
PLACE IN A CLEAN WORK AREA.
 REMOVE SCREWS SECURING THE
FACEPLATE ON. RELEASE CLIPS HOLDING
FACEPLATE ON.
 RELEASE TABS HOLDING THE 3 RIBBON
CABLES TO THE RADIO CHASSIS. SET
RADIO CHASSIS ASIDE.
 PLACE FACEPLATE IN A CLEAN, FLAT
WORK AREA FACE DOWN. BE CAREFUL
NOT TO SCRATCH THE FACEPLATE OF
THE RADIO.

 RELEASE CLIPS SECURING THE RIBBON
CABLES NOTED IN THE PICTURE AND
UNPLUG RIBBON CABLES.
 REMOVE FOUR #1 SCREWS FROM
FACEPLATE SECURING THE METAL
PLATE.
 REPLACE REMOVED SCREWS WITH
BRASS SPACERS. DO NOT OVER
TIGHTEN SPACERS.
 INSTALL PCB A TO THE ORIGINAL
BROWN TOUCH CABLE REMOVED
EARLIER IN THE PROCESS. MAKE SURE
TO INSERT WITH CONTACTS DOWN
AND TO LOCK THE CONNECTOR ONCE
THE CABLE IS SEATED CORRECTLY.

 INSTALL FCC CABLE 1 TO PCB A MAKING
SURE IT IS SEATED CORRECTLY AND
LOCKED INTO PLACE.
 INSERT FFC CABLE 4 INTO THE SLOT
WHERE THE ORIGINAL LCD RIBBON
CABLE WAS REMOVED EARLIER. LOCK
CABLE IN PLACE BY PRESSING TAB
DOWN.
 NOW PLUG FCC CABLE 3 TO BACK OF
INTERFACE PCB B. PLUG FCC CABLE 4 TO
BACK OF INTERFACE PCB B. PLUG FCC
CABLE 2 INTO PCB B.
 PLUG FFC CABLE 2 INFO FACTORY
POSITION AND FACTORY RIBBON CABLE
INTO PCB B AS SHOWN IN PICTURE .