IPEMA PlaygroundEquipment 6-foot Freestanding... User manual

Page 1 of 7
6-foot Freestanding Slide Installation
1 Playground Drive
Greenfield, IN 46140
1-800-667-0097
Colors depicted in photos
may not match your order.

Page 2 of 7
6-foot Freestanding Slide Installation
STEP: 1
Install posts according to the General
Information Guide. After installing
the posts, using one (1) M10*35 bolt,
two (2) M10 washers, and one (1)
M10 lock nut, attach the deck to the
pre-attached deck clamp, as shown
in the image. Repeat this process for
the other deck clamp.
STEP: 2
Connect half of the 3.5-inch tube
clamp to the guardrail using one (1)
M8*30 bolt. Set the guardrail into
place, then attach the second half of
the clamp using the hardware
provided in the clamp bag.
1 Playground Drive
Greenfield, IN 46140
1-800-667-0097

Page 3 of 7
6-foot Freestanding Slide Installation
STEP: 3
Using two (2) M10*25 bolts, four (4)
M10 washers, and two (2) M10 lock
nuts, connect the guardrail to the
deck. Repeat steps 2 and 3 for the
other guardrail.
STEP: 4
Using two (2) M10*25 bolts, four (4)
M10 washers, and two (2) lock nuts,
connect the handrail to the guardrail
as shown. Set the bottom end of the
handrail into footing. Information for
digging footers can be found in the
General Installation Guide.
1 Playground Drive
Greenfield, IN 46140
1-800-667-0097

Page 4 of 7
6-foot Freestanding Slide Installation
STEP: 5
Using one (1) M10*25 bolt, two (2)
M10 washers, and one (1) M10 lock
nut, attach the top of the stairway to
the deck on the opposite side of the
posts. Repeat this step for remaining
attachment points.
STEP: 6
Using one (1) M10*25 bolt, two (2)
M10 washers, and one (1) lock nut,
attach one stair handrail bracket to
the proper stair connection point.
Repeat this process for the remaining
connection points.
1 Playground Drive
Greenfield, IN 46140
1-800-667-0097

Page 5 of 7
6-foot Freestanding Slide Installation
STEP: 7
Using two (2) M10*25 bolts, four (4)
M10 washers, and two (2) M10 lock
nuts, connect the bottom of the
handrail to the stair.
STEP: 8
Take one (1) 3.5-inch flat clamp, and
loosely attach it around a post using
the bolts and nuts provided in the
clamp hardware bag. Repeat this
process on the other post. Then, use
one (1) M8*40 bolt, one (1) M8
washer, and one (1) M8 lock nut to
attach each side of the slide hood to
each clamp. Leave bolts loose until
slide is in place.
1 Playground Drive
Greenfield, IN 46140
1-800-667-0097

Page 6 of 7
6-foot Freestanding Slide Installation
STEP: 9
Using two (2) M8*20, two (M8)
spring gaskets, and two (2) M8
washers, attach the slide to the slide
end mount.
STEP: 10
Using two (2) M8*20 bolts, two (2)
M8 lock nuts, and four (4) M8
washers, attach the middle slide
support to the bracket under the
slide.
1 Playground Drive
Greenfield, IN 46140
1-800-667-0097

Page 7 of 7
6-foot Freestanding Slide Installation
STEP: 11
Using one (2) M10*45 bolts, four (4)
M10 washers, and two (2) M10 lock
nuts, attach one side of the slide to
the deck.
STEP: 12
Using one (1) M8*45 bolt, one (1) M8
washer, one (1) M12 washer, and
one (1) M12 Inner hex spiral nut,
attach the slide to one side of the
slide hood. Repeat this process for
the other side of the slide. Make sure
all bolts are properly tightened.
1 Playground Drive
Greenfield, IN 46140
1-800-667-0097