IsEasy LI4-30 User manual

IsEasy
INDUCTION HOB
InstructionManual
Specification of Vitro-Ceramic Hob
Model Name : LI4-30
Product size : 770x520 mm.
Built in size : 740x490 mm.
Voltage : 220V-240V , 50/60 Hz.
Power (total) :6800W

2
CONTENTS
BEFORE USE ......................................................................................................................................................
SAFETY INSTRUCTIONS ...................................................................................................................................
INSTALLATION ...................................................................................................................................................
ELECTRICAL CONNECTION .............................................................................................................................
INSTRUCTION FOR USE ...................................................................................................................................
TEMPERATURE LEVEL TABLE .........................................................................................................................
TECHNICAL INFORMATION ..............................................................................................................................
CLEANING ...........................................................................................................................................................
TROUBLESHOOTING GUIDE ............................................................................................................................
NOISES MADE BY THE HOB .............................................................................................................................
AFTER-SALES SERVICE ...................................................................................................................................

3
BEFORE USE
IMPORTANT: The cooking zones will not switch on if pots are not the right size. Only use pots bearing the
symbol “INDUCTION SYSTEM” (Figure below) or enameled pots. Place the pot on the required cooking
zone before switching the hob on.
EXISTING POTS AND PANS
Use a magnet to check if the pot is suitable for the induction hob: pots and pans are unsuitable if not
magnetically detectable.
Make sure pots have a smooth bottom, otherwise they could scratch the hob. Check dishes.
Never place hot pots or pans on the surface of the hob’s control panel. This could result in damage.
The bottom diameter of pots or pans should be at least 10cm.
SAFETY INSTRUCTIONS
YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT
This manual and the appliance itself provide important safety messages, to be read and always observed.
This is the warning / caution-safety symbol, regarding safety, warning of potential risks to users
and other
All messages relevant to safety specify the potential risk to which they refer and indicate how to reduce the
risk of injury, damage and electric shocks due to incorrect use of the appliance. Make sure to comply with
the following:
The appliance must be disconnected from the power supply before carrying out any installation
operation.
Installation and maintenance must be carried out by a specialized technician, in compliance with the
manufacturer’s instructions and the local safety regulations in force. Do not repair or replace any part of
the appliance unless specifically stated in the user manual.
The appliance must be earthed.
The power cable must be long enough for connecting the appliance, fitted in the cabinet, to the power
supply.
For installation to comply with the current safety regulations, an omnipolar switch with minimum contact
gap of 3mm is required.
Do not use multi-sockets or extension cords.
Do not pull the appliance’s power cable.
The electrical parts must not be accessible to the user after installation.
The appliance is designed solely for domestic use for cooking food. No other use is permitted (e.g.
heating rooms). The Manufacturer declines any liability for inappropriate use or incorrect setting of the
controls.
WARNING: The appliance and its accessible parts become hot during use. Care should be taken to

4
avoid touching heating elements. Children less than 8 years old shall be kept away unless continuously
supervised.
The accessible parts can become very hot during use. Children must be kept away from the appliance
and watched over to ensure they do not play with it.
Do not touch the appliance heating elements during and after use. Do not allow the appliance to come
into contact with cloths or other flammable materials until all the components have cooled sufficiently.
Do not place flammable materials on or near the appliance.
Overheated oils and fats catch fire easily. Pay attention when cooking food products rich in fat and oil.
This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand hazards
involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made
by children without supervision.
An air switch or circuit breaker (not supplied) should be installed in the compartment under the
appliance.
If the surface is cracked, switch off the appliance to avoid the possibility of electric shock.
The appliance is not intended to be operated by means of an external timer or separate remote control
system.
WARNING: Unattended cooking on a hob with fat or oil can be dangerous and may result in fire.
NEVER try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a
lid or a fire blanket.
WARNING: Danger of fire: do not store items on the cooking surfaces.
Do not use steam cleaners.
Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since
they can get hot.
After use, switch off the hob element by its control and do not rely on the pan detector.
CAUTION! Surface remains hot after use! Do not touch the top plate right after removing the
pot or the pan, as the top plate will still be very hot.

5
INSTALLATION
After unpacking the product, check for any damage during transport. In case of problems, contact the dealer
or the After-Sales Service.
For built-in dimensions and installation instruction, see in below figures
2. It is essential that the Radiant Cooktop is well ventilated and that the air intake and exit are not blocked.
Make sure the cooktop is correctly installed as shown in Figure 2.
For safety the gap between the hob and any cupboard above it should be at least 760mm.

6
ELECTRICAL CONNECTION
Disconnect the appliance from the power supply.
Installation must be carried out by qualified personnel who know the current safety and
installation regulations.
The manufacturer declines all liability for injury to persons or animals and for damage to property
resulting from failure to observe the regulations provided in this chapter.
The power cable must be long enough to allow the hob to be removed from the worktop.
Make sure the voltage specified on the rating label located on the bottom of the appliance is the same
as that of the home.
Black live wire L1, white live wire L2, green ground wire. The whole machine cannot be powered on if
any one of the black or white wires is not in contact.
Induction cooker related faults:
Communication failure: E8 (main board damage problem).
The wire reel is open: E1 (main board problem).
Open circuit or short circuit of NTC of wire reel stove surface probe: E2.
(Main board problem, the stove surface probe NTC is not inserted into the black section, or the stove surface
probe NTC is damaged).
High voltage fault: E3 (First, rule out whether the input voltage of your matches the input voltage of the
machine. If it is not a voltage problem, there is a problem with the motherboard).
Low-voltage fault: E4 (first rule out whether the input voltage of your matches the input voltage of the
machine, if it is not a voltage problem, there is a problem with the motherboard).
Customer Service Email: [e-mail]
(Please send relevant videos and pictures to our email address, and attach your Amazon order number.
After confirming the problem, we will definitely give you a satisfactory solution.)

7
INSTRUCTION FOR USE
To avoid permanently damaging the glass-ceramic top, do not use:
Pots with bottoms that are not perfectly flat.
Metal pots with enamelled bottom.
CONTROL PANEL LAYOUT
Switching the hob On/Off
To switch the hob on, press the button and the cooking zone displays light up. To switch off, press
the same button until the displays switch off.
If within 120 seconds of switching on, no heating zone is selected, the hob switches off automatically.
Switching on and adjusting cooking zones
Once the hob is switched on and the pan is positioned on the chosen cooking zone, select the
zone using the corresponding button: the display shows level 0.
Each cooking zone has various power levels, adjustable with the buttons,
going from “1”: min. level, to “9”: max. level.
Deactivation of cooking zones
Select the cooking zone you wish to switch off. Press the corresponding button.Press the key “ ” to set
the level to “0”. The cooking zone switches off and the residual heat indicator “H” lights up.
Child lock
This function locks the controls to prevent accidental switching on of the hob. To activate the
child lock function, switch on the hob and hold button for three seconds; the timer shows
Lo. Then the control panel is locked.
To deactivate the control panel lock, repeat the activation procedure. The Lo goes off and the hob is active
again.

8
Timer
The timer can be used to set cooking time for a maximum of 99 minutes (1 hour and 39 minutes) for
all cooking zones.Select the cooking zone to be used with the timer, press the button with the clock
symbol then set the desired cooking time using the buttons
of the timer function (see figure). After a few seconds, the timer begins the countdown. Once the set time
has elapsed, an acoustic signal sounds and the hob switches off automatically.
To deactivate the timer, press the “ ” button to set the display showing “00” or hold the button with the
clock symbol for at least 4 seconds.
Booster
When this button is pressed, the cooktop stops at Max Power in five minutes. Press the Button
again, and the cooktop will return to the last setting.
Please do not place hot pots or pans on the keypad! This could cause damage.
Auto switch off
The hob will automatically switch off when you did not set cooking time, forgot to switch off the hob, and did
not operate the hob for two hours.
CONTROL PANEL WARNINGS
Residual heat indicator
The hob is fitted with a residual heat indicator for each cooking zone. These indicators alert the user
when cooking zones are still hot.
If the display shows , the cooking zone is still hot. If the residual heat indicator of a given cooking zone is
lit, that zone can be used, for example, to keep a dish warm or to melt butter.
When the cooking zone cools down, the display goes off.
Incorrect or missing pot indicator – Error code “E0”
If you are using a pot that is not suitable, not correctly positioned or not of the correct dimensions for
your induction hob, the symbol ”E0” mean “no pot” will appear in the display (see figure at side). If
no pot is detected within 180 seconds, the hob switches off.
TEMPERATURE LEVEL TABLE
Temperature level
Type of cooking
Level use
(indicating cooking experience and habits)
Max level
9
Frying - boiling
Ideal for browning, starting to cook, frying deep frozen products,
fast boiling
High level
7-8
Browning -
sautéing - boiling
- grilling
Ideal for sautéing, maintaining a lively boil, cooking and grilling
6-7
Browning –
cooking – stewing
Ideal for sautéing, maintaining a light boil, cooking and grilling ,
preheating accessories

9
- sautéing -
grilling
Medium
level
4-5
Cooking –
stewing -
sautéing - grilling
Ideal for stewing, maintaining a gentle boil, cooking (for a long
period of time). Creaming pasta
3-4
Cooking –
simmering –
thickening -
creaming
Ideal for long-cooking recipes (rice, sauces, roasts, fish) with
liquids (e.g. water, wines, broth, milk),
creaming pasta
2-3
Ideal for long-cooking recipes (less than a liter in volume: rice,
sauces, roasts, fish) with liquids (e.g.
water, wines, broth, milk)
Low level
1-2
Melting –
defrosting –
keeping – food
warm - creaming
Ideal for softening butter, gently melting chocolate, thawing small
products and keeping just-cooked
food warm (e.g. sauces, soups, minestrone)
1
Ideal for keeping just-cooked food warm, for creaming risottos and
for keeping serving dishes warm
(with induction-suitable accessory)
Power off
0/H
Support surface
Hob in stand-by or off mode (possible end-of-cooking residual
heat, indicated by an “H”)
Note: The data in the table is for guidance only. The relation between the heat setting and the
cooking zone consumption of power is not linear. When you increase the heat setting it is not
proportional to the increase of the cooking zone consumption of power.
The power of the cooking zones can be different in some small range. It changes with the material and
dimensions of the cookware.
TECHNICAL INFORMATION
Voltage: 220 - 240 V 50/60 Hz
Max. power: 6800W
Top Left: 1200W BOOSTER:1500W
Down left: 1800W BOOSTER:2000W
Middle:2400W BOOSTER:2600W
Down Right: 1200W BOOSTER:1500W
Only one zone can be use the function of “Boost“ at the same time per left or right side.
CLEANING
Do not use steam cleaners.
Before cleaning, make sure the cooking zones are switched off and that the residual heat
indicator (“H”) is not displayed.
IMPORTANT: Do not use abrasive sponges or scouring pads. Their use could eventually ruin the glass.
After each use, clean the hob (when it is cool) to remove any deposits and stains due to food residuals.
Sugar or foods with a high sugar content damage the hob and must be immediately removed.
Salt, sugar and sand could scratch the glass surface.
Use a soft cloth, absorbent kitchen paper or a specific hob cleaner (follow the Manufacturer’s
instructions).

10
TROUBLESHOOTING GUIDE
Read and follow the instructions given in the section “Instructions for use”.
Check that the electricity supply has not been shut off.
Dry the hob thoroughly after cleaning it.
If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table
for instructions.
If the hob cannot be switched off after using it, disconnect it from the power supply.
Error
code
Possible Cause
Remedy
E0
No Pan or did not detect the pan
Put on the pan
E2
NTC short or open
Contact the after-sales service and specify the
error code
E3
High voltage
Contact the after-sales service and specify the
error code
E4
Low voltage
Contact the after-sales service and specify the
error code
E5-E8
A lot of possibilities, the cooktop must
be sent in for repair
Contact the after-sales service and specify the
error code
C/C-C-C-C Error: automatic safety shut-off for liquid overflow
This means that the touch panel was watered with liquid.
NOISES MADE BY THE HOB
Induction hobs can make whistling or crackling sounds during normal operation, these actually come from
the pots and pans as a result of the characteristics of the bottoms (for example, bottoms made of several
layers of material, or uneven bottoms). These noises vary depending on the pots and pans used and the
amount of food they contain, and are not indicative of a defect of any kind.
In addition, the induction hob is equipped with an internal cooling system to control the temperature of
electronic parts; as a result, during operation and for several minutes after the hob has been switched off,
the noise of the cooling fan will be audible. This is perfectly normal and indeed essential for proper
functioning of the appliance.