1. Before operating, make sure that both the skateboard and the remote control are fully charged.
2. When the skateboard is in power-off state, you can push the skateboard to power on it automatically.
3. Low speed mode is recommended for beginners.
4. If the remote is not connected to the skateboard, the remote will automatically shut down in about 30
seconds. If the remote and the skateboard are connected, the remote will not automatically shut down.
You must shut down the skateboard and wait for about 30 seconds, and the remote will shut down
automatically.
Notice:
Reverse Button
Accelerator/Brake Wheel
Power Button
Signal Indicator
Speed Level/Skateboard Battery
Level/Remote Battery Level
/Remote Charging Indicators
Remote Battery
Level/Remote Charging Indicators
Lanyard
Micro USB Charging Port
Power Button:Click to turn on. Long press to turn off
Signal indicator: When the skateboard and the remote control are not paired, the signal
indicator is always-on green light. After the skateboard and the remote control are paired
successfully, the signal indicator light will flash green.
Reverse button: When the skateboard is at rest, press and hold the Reverse button to
switch between forward and reverse.
Indicators beside the skateboard icon:
1. Within 3 seconds of turning on the remote control, the 4 lights next to the car icon will
flash, indicating the battery levels of the remote control.
2. After the remote is successfully paired with the skateboard, the indicators indicate the
battery levels of the skateboard.
3. Then press the power button once to switch speed levels, and the four lights indicate
four speed levels respectively.
Battery Level Indicator:：1. When the battery level of the remote is lower than 20% or
when charging with 20% or lower battery level, the indicator light flashes red.
Remote
03
