It’s Exciting Lighting IEL-4402 User manual

IEL-4402
Battery Powered White and Amber Flicker
Vertical Wall Sconce with Remote
CONTENTS
REQUIRED
• A - Sconce Cover* x1
• AA Batteries
(Not Included)
• B - LED Back Plate x1
• C - Remote Control x1
*Sconce Cover may vary in style/shape
Mounting Holes C
B
A
Front of LED Back Plate
Back of LED Back Plate
Power Button
Mounting Posts
Battery Cover
INSTALLATION
1. Remove rear battery cover and place 6 AA alkaline batteries (not included) with the polarity
as shown in the battery door. Replace battery cover.
IMPORTANT: pay careful attention to the polarity of the batteries and ensure they are inserted
in the correct direction as shown on the battery cover illustration. Failure to install batteries in
the correct direction may cause damage to the product.
2. Determine where the product is to be mounted and insert nail or screw (not provided) in the wall.
Mount LED Back Plate (B) on the wall by sliding it onto the nail or screw head like hanging a picture frame.
3. Slide the Sconce Cover (A) onto the LED Back Plate (B) by fitting the holes in the top of the Sconce Cover
(A) onto the Mounting Posts to hold it in place.
4. Push the Power Button located on the bottom of the unit to power the unit on.
To enter amber flicker LED mode, press again to switch from white LED to amber flicker LED.
Push the Power Button again to power the unit off.
5. Remote control instructions: Remove pull tab between the battery and the connector. To activate
light press either the white or the amber flicker button, To turn the light OFF at any time, press the
power button.
x2
x2
x2

SAFETY
1. Do not disassemble the back plate.
2. To prevent equipment damage and possible injury, never mix batteries with different chemistries or voltages in
the equipment at the same time.
3. Consumed batteries need to be disposed of properly. Follow the disposal instructions on the battery package.
Battery selling retailers provide special containers for environmentally friendly disposal.
4. Remove batteries from unit for long term storage to prevent damage from battery leakage.
INSTALLING & REPLACING BATTERIES
1. Remove battery compartment cover on LED Back Plate. Insert new AA alkaline batteries.
WARNING: Pay careful attention to the polarity of the batteries being inserted. NEVER insert batteries
with the " + " of one battery facing the " + " of the other. Inserting the batteries incorrectly may cause
spark, fire or explosion.
Replace battery compartment cover and hang LED Back Plate back on wall.
For remote control: Slide open battery tray and replace old battery with a new CR-2025 button cell battery.
2.
3.
IEL4402
Battery Powered White Plus Amber
Vertical Wall Sconce (includes remote)