Italian Shades Poker User manual

INSTALLATION INSTRUCTIONS POKER OFFSET UMBRELLA
“Italian Shades Corporation” italianshades.com TEL. [phone] Page !1
The Kit contains:
N° 16 bolts M12 X 40
N° 4/4 bolt M 8X90 with nut and
washer
N° 16/16 hexagon screw head bolts
M8X25
N° 24/24 set screw M8X20
N° 4/4 which handle
N° 4/4 which handle M8X25
N° 1 allen wrench 6
N° 1 allen wrench 4
Necessary Tools:
-Ladder
-Leve;
-MM 13 wrench
-MM 19 wrench
INTRODUCTION
Double and Poker models have a specialized blocking system for the canopy, called
“Spherical Joint”, which provides an optimal umbrella’s leveling and prevent
possible breakage caused by wind.
To assure safety in windy conditions, please be sure to tighten
all bolts and screws before using.

INSTALLATION INSTRUCTIONS POKER OFFSET UMBRELLA
“Italian Shades Corporation” italianshades.com TEL. [phone] Page !2
PLACEMENT - Poker and Double models can be mounted with a MM 1200X1200 ballast base fixable to
the ground, or directly to the ground, or with a steel plate.
ATTENTION : VERIFY THAT FLOORING HAS APPROPRIATE MECHANIC CHARACTERISTICS.
THE BALLAST WEIGHT SHOULD BE MORE THAN 320 KG.
Place the base rotated 45°in the direction of the umbrella sides.

INSTALLATION INSTRUCTIONS POKER OFFSET UMBRELLA
“Italian Shades Corporation” italianshades.com TEL. [phone] Page !3
THE DISTANCE BETWEEN UMBRELLAS SHOULD BE 20 CM.
-PLACE THE BASE ON A FLAT SURFACE.
-SCREW THE CENTRAL TUBE TO THE BASE WITH THE 8 BOLTS M 12X40
PLACE THE BALLAST IN THE DEDICATED COMPARTMENTS.
INSERT THE RIBS IN THE POLE AND TIGHTEN STRONG.

INSTALLATION INSTRUCTIONS POKER OFFSET UMBRELLA
“Italian Shades Corporation” italianshades.com TEL. [phone] Page !4
ATTENTION : Reassemble the spherical cap and align the 2 reference points in the same direction of
the arm.
Do not tighten strong the lateral set screws at this point.
Unroll the cable and feed it through the pulley.
-Attach the cable to the winch handle with the small cable tie.
Before opening the umbrella, make sure the ribs are not tangled - free from the other ribs to open.
-Control that the rib with the holding rib is directed to to pole.
If necessary, adjust the position by rotating and tilting the umbrella manually.
When the umbrella is in the correct position, you can fix it definitively.
- Close the umbrella
- Strongly tighten the 4 bolts M8 of the cuff (fig 1)
Tighten the 2 lateral set screws in order to block the canopy rotation (Fig 2)
To a s s u r e s a f e t y i n w i n d y c o n d i t i o n s , p l e a s e b e s u r e t o
tighten all bolts and screws before using.