IXIUM 808 User manual

Custom Manuals Provided by www.ixium.co.uk
808 Car keys Micro Camera
720 x 480 Video recording at 30FPS
1280 x 960 Photo Resolution
Thank you for purchasing an 808 Car Key Micro Camera from WeCostLess.co.uk. Below you will find
instructions for using the cameras controls and general information a out the function of the device. If you
have any questions that are not answered here don't forget you can contact us y visiting eBay and sending
us a message!
1. Power On/Off
2. Video/Photo Capture Button
3. Microphone
4. Camera Lens
5. Indicator Light
6. Mini USB charging Socket
7. Reset switch (recessed)
8. Micro SD card slot (SD Card NOT Included)
1. Device Power On/Off
Press and hold utton (1) to turn device on. Light illuminates to indicate device is ON.
Press and hold again to turn device off. Light goes out to indicate device is OFF.
2. Video/Photo Capture Button
Photos:
After turning the unit on, the light is illuminated to indicate device is ready for use. Press utton (2)
to take a photo. The light will momentarily go out to indicate the photograph has een taken and
then come ack on. Each Press will take another photograph.
Videos:
After turning the unit on, the light is illuminated to indicate the device is ready for use. Press and
hold utton (2) to egin video recording. The LIGHT FLASHES 3 TI ES AND THEN GOES OUT
to indicate that the device is recording. The Device will continue recording until utton (2) is
pressed once to stop recording. The Light comes ack on to indicate recording has stopped.
If left recording, the device will continue until the memory card is full, the attery runs out, or
utton (2) is pressed.
3. Microphone
The Microphone is used for recording audio during video capture. Do not o struct or the sound
quality will e significantly reduced.
4. Camera Pinhole
Pinhole recess for camera lens. Be sure to keep clean and uno structed for maximum clarity in your
video captures.
5. Indicator Light
Light indicates device status.
On Charge: Yellow light on solid (full charge approximately two hours).
In Use: Waiting = yellow light on solid.
Low Battery = yellow light flashes slowly
6. Mini USB Charging Socket & Charging The Device
Mini USB charging socket for use with the included Mini USB charging ca le connected to a desktop

Custom Manuals Provided by www.ixium.co.uk
or laptop computer for charging. You can also use car or mains USB charging adaptors. We
recommend an overnight charge (at least 8 hours) for maximum capacity of up to 2hours. Actual
time will vary slightly due to su tle differences in the atteries.
7. Reset Button
In the event of a software crash where the uttons will not respond you can press and hold the
reset utton with a paperclip for approximately 3 seconds, to power off and perform a full factory
reset on the device. This will also reset the internal clock.
8. MicroSD Card Slot (SD Card NOT Included)
This slot houses the MicroSD card used to store the photos and videos you capture. It supports
MicroSD cards from 2G to 16G in size. The ta le elow gives you an indication of the quantity of
photos or videos you can take on a single memory card. The values within are for Photos OR
Videos, not oth.
Photos Video
2Gb 13500 40mins
4Gb 27000 80mins or 1hour 20mins
8Gb 54000 160mins or 2hours 40mins
16Gb 108000 320mins or 5hours 20mins
Approximate Memory Card capacity for Photos OR Videos
Viewing Videos/Photos
Retrieving your photos and videos is the same as most modern cameras. Simply remove the MicroSD card
from the device and place into your card reader. Navigate to the card reader disc drive on your computer
and enter the “DCIM” folder. All files stored on the SD card y the device are named “EKEN0001” and
continue upwards numerically. Photos have the extension .jpg and videos the .avi extension.
Time Set
The device comes with a feature which em eds the current time and date on to your captured photos and
videos. To set the time and date of the device, please follow the instructions elow.
1. Place the SD card into your computers card reader.
2. Make sure you are on the “root” (top level) folder of the SD Card.
3. Create a new file with the name TAG and extension .txt (TAG.txt)
4. Open the file and write the following information (exactly as shown):
[date]
2010/12/31
12:00:00
This example would set the unit to 12am on the 31
st
of Decem er 2010. You can customise the
information to represent the current time in your area. Save the changes to the file (TAG.txt) and place
the SD card ack into the Camera device. When you next turn on the device it will automatically read
the TAG.txt file and, change its internal date and time settings to the information you have provided.