IZZIWOTNOT Baiely Manual

08 November 2013(ZEQ 01)

Introduction
The Bailey sleigh bed is designed to be used from birth to approximately 4 years.
The base can be fixed in 3 positions. The lowest position being the safest (refer to safety notes).
The cot can be converted into a toddler size bed (approximately from 18 months to 4 years of age).
Important notes
Do not discard any packaging until you have checked the parts against the list below.
Please take a few minutes to read through the assembly instructions.
Unpack your sleigh bed carefully onto a soft level surface such as a carpeted floor.
Familiarise yourself with the parts by comparing them with the checklist provided below.
The recommended mattress size for this sleigh bed is 1400 x 700 x100mm.
There is a small line engraved on each of the side rails (see diagram on page 3).
The engraved line should face the inside of the sleigh bed.
These lines determine the maximum height of the mattress when the base is in the highest position.
(refer to safety notes).
The cot conforms to BSEN716-1 2008 - Safety Standards for cots
The toddler sized bed conforms to BS8509 : 2008+A1:2011 - Safety standards for childrens beds
Parts checklist
Ref
A
B
C
D
E
F
G
H
Part
Description
Blanking Screws
Large Bolt(M6x100mm)
Medium Bolt(M6x55mm)
with shank
Barrel nut(10x15mm)
Barrel nut (10x20mm)
Dowel(Dia8x40mm)
Allen key
Medium Bolt(M6x60mm)
Qty
8
8
4
8
4
4
2
8
2

Item Name Qty
1End 2
2 Side Rail 2
3Apron 2
4 Bed Base 1
Parts checklist
2

Assembly
1. Attaching the aprons to ends.
B
B
BX8 DX8 FX4
IMPORTANT INFORMATION
GX1
When constructing the Sleighbed do not fully
tighten fixings until you reach the last step.
2
3
B
B
D
D
3
2
B
B
F
B
B
2. Positioning the bed base.
(This assembly guide shows the base in the lowest position).
Bed End
High
Mid
Low
The base can be fixed in 3 positions.
The lowest base position is the safest
and the only one you should use once
your baby can sit un-aided.
3

Assembly
3. Attaching the bed base.
C
CX4 EX4
C E
E
C
E
E
E
4. Turn over with assistance (One person each end).
Cap any un-used holes with blanking bolts.
C
C
AX8
GX2
4

Assembly
5. Positioning the first side rail.
(Make sure the mattress height mark is on the inside of the cot).
1
6. Attaching the first side rail.
HX4
H
1
H
H
H
5

Assembly
6. Positioning the second side rail
(Make sure the mattress height mark is on the inside of the cot).
1
7. Attaching the second side rail. HX4
H
H
1
H
H
IMPORTANT INFORMATION
Please ensure all bolts are now fully tightened
before using the cot-bed.
6

To change from cot to toddler bed remove the two side rails.
The Bailey Sleigh bed can be used as day bed.
To change from toddler bed to day bed attach one side rail only.
Assembly
7
The Bailey Sleigh bed can be used as a toddler sized bed.

SAFETY NOTES :
Excessive chewing may damage the wood and cause splintering. If any part is damaged, stop using
the cot bed until the correct replacement part has been obtained from Izziwotnot.
Do not allow children to climb on the furniture. The safety of your child is your responsibility.
Before use, please ensure each item of furniture is on a stable, level surface.
Never use the item of furniture if any parts are broken or missing.
To avoid the risk of suffocation, keep all plastic bags and packaging out of reach of babies and young
children.
All assembly fittings should always be tightened properly. Care should be taken that no fittings are
loose, because the child could trap parts of the body or clothing which could pose a risk of
strangulation.
Warning: Be aware of the risk of open fire and other sources of strong heat, such as electric bar fires,
gas fires etc., in the near vicinity of the cot.
Warning: .Do not use the cot if any part is broken, torn or missing and use only spare parts approved
by the manufacturer.
Warning: Do not leave anything in the cot or place the cot close to another product, which could
provide a foothold or present a risk of suffocation or strangulation, e.g. strings, blind/curtain cords etc.
Warning: Do not use more than 1 mattress in the cot.
The lowest base position is the safest and should always be used as soon as baby is old enough to
sit up.
The thickness of the mattress chosen must not reduce the internal depth (from mattress surface to top
of the side) to less than 500mm with the base in the lowest position or 200mm with the base in the
highest position. The cot bed sides have an engraved line on the inside indicating this height.
The mattress to be used with this cot should be no more than 30mm shorter or narrower than the
internal length or width of the cot bed.
Never pivot or drag the item of furniture when moving. The item of furniture must always be lifted by at
least two people.
To prevent injury from falls, when a child is able to climb out of the cot the cot shall no longer be used
for that child.
Children are likely to play, bounce, jump and climb on beds, therefore the child’s bed should not be
placed too close to other furniture or windows, and should be placed either tight to any wall or
have a gap of 300mm between the wall and the side of the bed.
When cot is converted into a bed, it is to be used by one child aged 18 months to 4 years.
WARNING : Do not place this child’s bed near heat sources, windows and other furniture.
WARNING : Do not use this child’s bed if any part is broken, torn or missing.
This product is designed to be dismantled for storage or transportation.
CARE OF YOUR PRODUCT :
Periodically check all fittings to ensure that none have come loose. Any loose fittings must be
tightened using the correct tool.
Your cot bed can be cleaned by wiping with a damp cloth and drying with a soft dry cloth.
Never clean with abrasives, ammonia based, bleach based or spirit type cleaners.
Take care when handling or moving the cot bed. Careless handling can damage wooden furniture.
Care and Safety
8

CUSTOMER SERVICE:
If you need assistance please contact our Customer Service Team on 0161 830 1919.
Alternatively please contact the retailer from whom you made your purchase.
GUARANTEE - CUSTOMER COPY
All our products are made using the highest quality materials and are manufactured to
British Standards, some of the highest quality standards in the world.
We guarantee our furniture products or part thereof, for a period of one year from the date of delivery
against faulty manufacture. This guarantee is not effective against damage caused as a result of
incorrect use or accidental damage. This in no way affects your statutory rights.
To validate this guarantee, please fill in the coupon and retain for future reference:
IZZIWOTNOT, 520 Metroplex, Broadway, Salford Quays, Manchester, M50 2UE
Title(Mr/Mrs/Miss/Ms)
Address
Daytime Telephone Number
Product Purchased
Purchased Date
Where Purchased
First Name
Email
Price
Surname
Postcode
If you would like to receive further information regarding new products, promotions and special offers from IZZIWOTNOT please tick
the box provided:
Post
Email www.izziwotnot.com / [e-mail]
GUARANTEE
All our products are made using the highest quality materials and are manufactured to
British Standards, some of the highest quality standards in the world.
We guarantee our furniture products or part thereof, for a period of one year from the date of delivery
against faulty manufacture. This guarantee is not effective against damage caused as a result of
incorrect use or accidental damage. This in no way affects your statutory rights.
To validate this guarantee, please fill in the coupon and return to:
IZZIWOTNOT, 520 Metroplex, Broadway, Salford Quays, Manchester, M50 2UE
Title(Mr/Mrs/Miss/Ms)
Address
Daytime Telephone Number
Product Purchased
Purchased Date
Where Purchased
First Name
Email
Price
Surname
Postcode
If you would like to receive further information regarding new products, promotions and special offers from IZZIWOTNOT please tick
the box provided:
Post
Email
9
www.izziwotnot.com / sal[email protected]