J.Burrows LEVO DELUXE CHAIR JBLEVDHBBK User manual

Assembly Instructions
Page 1
This chair has a load rating of 135kg
LEVO DELUXE CHAIR
JBLEVDHBBK/JBLEVDHBGY

C-L / C-R
H
X6
1
Please check you have all hardware components before assembling.
If you are missing any hardware components please contact My Zone on
Tel: [phone] or Email: [email protected]
Please ensure you have the name of the item, store purchased from, hardware part required and quantity.
Please retain your receipt to validate warranty
,
. Enjoy your new purchase!
G
Assemble Item On A Clean Flat Surface

Page 3
Step 1
Step 2
Note: Turn the Star Base (E) upside down. Press the Casters (F) into holes at the end of each leg.
Turn the Star Base (E) upright and insert Gas Lift (D) into the center hole of Star Base (E).
Note: Align the Armrests (C-L / C-R) on the bottom of the Seat Cushion (B). Tighten the screws.
D
E
F
G
H
B
C-R
C-L
Torque 5 Nm

Page 4
Step 3
Step 4
Note: Place assembled seat on the Gas Lift (D). Push down firmly until connection is secure.
Note: Check to make sure the knob on the rear left side of the Seat Plate is loose before proceeding
with this step.Align Back Cushion (A) with Seat Cushion (B) by GENTLY inserting the back
support plate into the rear hole of the Seat Plate as shown. TIGHTEN by using the knob on the
rear left side of the Seat Plate.
B
F
E
D
C-L
C-R
A
B
C-L

Page 5
Step 5
Your Levo Deluxe Chair is now complete and ready for use.
IMPORTANT NOTE: Periodically check and re-tighten screws.
Officeworks Superstores Pty Ltd 236-262 East Boundary Road East Bentleigh 3165 Australia

LEVO DELUXE CHAIR
FEATURES
* Chair Height Adjustment
- To increase chair height pull
lever upward while liing body
weight slightly off the seat.
- Release leaver at desired height.
- To lower chair height sit fully into
the chair and pull lever upward.
- Release leaver at desired height.
Your feet should be resng flat on
the floor.
* Back Tilt
- Sing in the chair pull lever up.
Move your upper body fore and
a to a comfortable posion.
When comfortable lock the
posion by pushing the lever
down.
* Seat Tilt
- Sing in the chair pull lever up.
Move your body to a comfortable
posion. Lock the posion by
pushing the lever down.
* Back Height Adjustment
- Loosen knob on mechanism.
With both hands raise or lower
back rest to desired height and
re-ghten knob on mechanism.
ARM
SWIVEL
* Arm Swivel Adjust
Gently swivel the arm rest pad
clockwise or counter clockwise
to achieve desired posion.
* Arm Height Adjust
Pull lever up whilst moving the
arm up or down. Release lever
at desired height.
ARM
HEIGHT
SEAT TILT
BACK
HEIGHT
BACK
TILT
GAS-LIFT
HEIGHT