Jack Grills JGSDBL User manual

1
Version: APR13
OWNER’S MANUAL:
Model # JGSDBL Double Side Burner
JACKSON GRILLS INC.
#106-2480 Mt. Lehman Rd.
Abbotsford, BC V4X 2N3
TEL: [phone]
FAX: [phone]
SUPPORT: [email protected]
WEB SITE:www.jacksongrills.com
FOR OUTDOOR,
BUILT-IN USE ONLY
!WARNING!
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odor continues, keep away from
appliance and immediately call your gas
supplier & fire department.
!WARNING!
1. Do not store or use gasoline or other
flammable liquids in the vicinity of this
appliance.
2. Do not store disconnected propane
tanks in the vicinity of this appliance.

2
TABLE OF CONTENTS
Certification & Testing 2
Safety Warnings 3
Package Contents Checklist 3
Side Burner Parts Blow-Up 4
Installation Instructions: (Built In Version) 5-6
Leak Testing: 6
Natural Gas Conversion: 6
Lighting Instructions: 6
Warranty: 7
CERTIFICATION & TESTING
This side burner has been tested by Labtest Certification (LC) and has been tested to ANSI Z21.58a-1198 & CGA
16a-M98, and Certified for Canada and the USA.
NOTE: The use and installation of this product must conform to local codes. In the absence of local codes, use the
National Fuel and Gas Code, ANSI A223.1, Storage and Handling of Liquefied Petroleum Gasses, NFPA / ANSI 58.

3
!SAFETY WARNINGS!
SAFETY FIRST:
Please carefully read all warnings and precautions prior to operating your Side Burner.
1 This accessory is for outside use only, and shall not be used in any building, garage, enclosed area or
vehicle.
2 This Side Burner is set up from the factory for use with Propane Gas (LP). (Propane Cylinder /Tank not
included)
.
3 Do not use gasoline, alcohol or other volatiles for lighting purposes.
4 The Propane (LP) gas supply cylinder must be constructed and marked in accordance with the
specifications for propane gas cylinders of the US Department of transport (DOT) CFR 49 or the National
Standards of Canada, CAN/CSA B339, Cylinders, Spheres and Tubes for the Transportation of Dangerous
Goods.
5 Do not alter this accessory in any manner.
6 Do not touch any metal surfaces on this side burner until it has completely cooled to avoid burns, unless
wearing protective gear. (Pot holders, gloves, BBQ mittens, etc.)
7 It is essential to keep the valve compartment, burners, and circulating air passages clean and free of
obstructions and debris. Inspect the grill before each use.
8 Do not store any spare propane cylinders within 10 feet of this Side Burner.
9 Please note that propane (LP) is explosive under pressure, heavier than air, and settles and pools in low
areas, which can create an explosion hazard.
10 Caution: contact with propane gas can cause freeze
burns to your skin.
11 Dented and rusted propane cylinders may be
hazardous and should be checked by a propane
gas supplier, before use.
PACKAGE CONTENTS CHECKLIST:
The following parts are included in this side burner package:
1 x Side Burner Body with Lid (attached)
1 x Stainless Steel Inlet Flex Hose
2 x Stainless Steel Cook Grid
2 x Burners (AKA Burner Top)
2 x Natural Gas Orifices (for Natural Gas Conversion)
1 x Owner’s Manual
!WARNING!
Failure to follow all
manufacturer’s instructions
could result in serious bodily
injury and/or property damage.

4
Flexible Fuel
Line: JF-83
Cook Grid:
JG-19 x 2
Burner:
JB-22 x 2
Electrode:
JE-14 x 2
Manifold:
JF-86
Gas Valve:
JF-100 x 2
Control Knob:
JK-14 x 2
Chrome Bezel:
JK-17 x 2
SIDE BURNER PARTS LIST
Lid with Handle:
JH-002
Shoulder Bolt:
JH-001 x 2
Main Body (Call
Dealer)
Burner Support
Plate:
JB-23 x 2
Burner Fuel
Line: JF-84
x 2
Venturi:
JF-85 x 2

5
Figure 1: Built In Cut-Out Dimensions**
BUILT IN MODEL INSTALLATION:
NOTE: this side burner kit DOES NOT FIT Jackson Cart model barbeques.
STEP 1
Cut hole in cabinet to size as shown in Figure 1; ‘Cut Out Dimensions’
(High-lighted in Yellow).
*These accessories require a bottom support for the unit to sit on when installed.
** These dimensions are the actual cut out dimensions for the built in units in non-combustible applications.
!WARNING!
SHUT OFF FUEL before
installing this side burner
assembly.
Rev Feb 2012

6
Figure 7
Figure 8
Figure 4
STEP 2
Install inlet fuel line and connect to Side Burner at the 3/8” flared
connection under the side burner. (Sealant is not required at this
connection).
PROPANE: Please ensure that the fuel source has been regulated so that the inlet pressure is set at 11” Water
Column.
NATURAL GAS: please ensure that inlet pressure does not exceed 4 1/2” Water Column. (Also see ‘Natural Gas
Conversion’ below)
LEAK TESTING:
STEP 1
Mix a solution of liquid dish soap and water (or obtain profession leak detector liquid).
Turn on Gas.
STEP 2
Spray or brush detector liquid thoroughly on all fuel line connections (Fig. 6). If soap
bubbles are generated at any connection, tighten the fitting and re-test. If a leak is
detected that cannot be successfully repaired, immediately turn off the gas and
contact your dealer for further assistance.
LIGHTING INSTRUCTIONS
1. Turn the main gas supply ON.
2. Depress the side burner control knob down slightly and turn SLOWLY counter clock wise until the ‘click’ of the
igniter is heard. (This side burner has a built in ignition system).
3. If the side burner does NOT light, turn the control knob to the OFF position and try again.
4. Once the burner has lit, turn the control knob counter clock wise to the desired heat level.
To turn the unit off, turn the gas control clockwise to the OFF position.
NATURAL GAS CONVERSION
1. Remove both Cook Grids and Burners,
2. Remove the two Propane Orifices, using a ¼”
Socket Wrench with an extension, and a
7mm socket (Fig. 7)
3. Lightly coat threads of the two Natural Gas
Orifices with Teflon Tape or Gas Fitting Dope.
4. Install both Natural Gas Orifice into Side
Burner (Fig. 8)
TECH TIP
It is recommend that a Certified Gas
Fitter be used to install fuel lines
and other fuel related components.
TECH TIP
Do NOT over tighten orifice; threads
can easily be broken off!

7
Limited Warranty:
MODEL: JGSBDBL Side Burner
Jackson Grills Inc. warrants the materials and workmanship in this accessory to be free of defects for two years from
the date of purchase.
Limited Warranty Subject to the following Conditions & Limitations:
NOTE1: Shipping and Labor Charges are NOT covered
NOTE2: Bill of Sale MUST be presented at time of warranty claim.
Jackson Grills Inc. warrants its products to the
original purchaser only (NO EXCEPTIONS).
The bill of sale (proof of purchase) and serial
number will be required in order to claim
warranty from your authorized dealer.
This factory warranty is non-transferable and
may not be extended under any circumstances.
This Limited Warranty does not cover any
damage caused by misuse, lack of maintenance,
hostile environments, accident, alterations,
abuse or neglect, including scratches, dents,
corrosion, or discoloring by heat (all stainless
steel will discolor), and abrasive or chemical
damage resulting from use of harsh cleaners.
Should deterioration occur to the point of
non-performance within the duration of the
warranted coverage, a replacement will be
provided in the first year only. This warranty
extends to the repair or replacement of
warranted parts that are defective in materials
or workmanship provided that the product has
been operated in accordance with the operation
instructions and under normal conditions.
After the first year Jackson Grills Inc. reserves
the right to fully disengage all obligations with
respect to this Limited Warranty by refunding
the original warranted purchaser the original
wholesale price of the warranted parts.
Genuine Jackson parts must always be used;
use of parts supplied by other manufacturers
will nullify the warranty.
The installation must be done in accordance
with the installation procedures described in
the included owner’s manual.
Jackson Grills Inc. or its parties will not be
responsible for the installation, labor or any
other costs or expenses related to the refitting
of the warranted part, and such expenses are
not covered by this warranty.
Notwithstanding any provision contained in
this Limited Warranty, Jackson Grills Inc.
responsibility under this warranty is defined as
above and it shall not in any event extend to
any incidental, consequential, or indirect
damages.
Jackson Grills Inc. neither assumes, nor
authorizes any third party to assume, on its
behalf, any other liabilities with respect to the
sale of this product.
Jackson Grills Inc. reserves the right to inspect
any parts prior to approving warranty claim.
Jackson Grills or its representatives shall not
be liable for ANY shipping charges, labor
charges or duties.