ASSEMBLY INSTRUCTIONS
THIS TREE IS FOR INDOOR USE ONLY!
Retain carton and instruction sheet for storage and further purposes.
Each carton contains three tree sections ABC and one metalstand D.
1. Choose a locationwhere the tree is to be displayed.It should be ona levelsurface.
Make sure finalassembly stable enough to hold the tree upright.
2. Take out the metalstand and assemble as below figures shown.
1) Tree stand consists ofa metalstand and a single eye bolt as Fig.1.
2) Open the stand to a 90 degree angle untilthe hole lines up withthe hole on the tube as Fig.2.
3) Insert the tree bottomCinto the hole as Fig.3.
4) Screw the eye bolt to tighten the tree bottom.
3. After tighten the tree bottomC into metal stand D,insert the middle section Binto tree bottomC,
then insert tree top Ainto middle section B as Fig.5.And Connect each section's light connectors as photo.
Fig.5
Fig.1 Fig.2
Fig.4
Fig.3
STORAGE
First unplug the power cord from the wall outlet.
Remove allholiday decorations,disassemble the three tree sections and secure themin place.
Alltree parts canbe replaced in its originalcarton and should be stored in a cooland dryplace.
WARNING FOR SAFETY USE
1. Never allow any part ofthe tree to contact a source ofheat or flames.
2. Caution: Artificial trees have small parts which may pose a choking hazard if detached
fromthe branches. Keep out ofreachofsmallchildrenand pets.
3. Always position your tree light string cord or any extension cord so that they will not be a
4. Always fully insert electricalplugs into a receptacle.
TROUBLE SHOOTING TIPS
For pre-lit trees, if the tree does not illuminate:
1. Please check to make sure that the power cord is plugged into the walloutlet.
2. Please check for loose,broken or missing light bulbs and replace as needed.
3. Please check the plug fuse and replace as needed.
SPARE PARTS
For pre-lit tree, plug fuses and bulbs are included.
Please check attached manualfor replacement guide.
Ifextra parts are needed, please contact our customer service center.
Email: customerservice@winnersarts.com or Call toll-free: 1-844 946 8733
4. Shape your penciltree as Fig.6.Working your way up fromthe bottom.
The penciltree is easyto set up in a short time.
Fig.6
5. You can add holiday decorations to beautify this pencil tree.
6. The pencil tree is pre-strung, you can connect the plug to the wall outlet.
All lights should illuminate completing the assembly of your tree! Enjoy your holiday!
hazard to the elderly,childrenand pets.
