Jade Plaisir 1000 Operating and maintenance manual

Jade Bathrooms Products Inc. 11900 J.J. Joubert, Suite B, Rivière des Prairies, Québec, Canada, H1E 7E7
Tel: [phone] • Fax: [phone] • www.jadebath.com
Customer Service: 866-333-0555
1
Plaisir 1000
Installation Procedure
Professional Installation Recommended
TUB DIMENSIONS BEFORE INSTALLATION
ATTENTION:
Please inspect the tub carefully for any
defect or damage before installation.
Once installed, any defect or crack will
not be under warraty.
1) Floor must be at & level.
2) Floor must be built to support 65-lbs per
square foot load.
3) Delicately unpack the tub and inspect for any
defect or damage before installation.
4) See dimensional drawings to locate drain
position.

Jade Bathrooms Products Inc. 11900 J.J. Joubert, Suite B, Rivière des Prairies, Québec, Canada, H1E 7E7
Tel: [phone] • Fax: [phone] • www.jadebath.com
Customer Service: 866-333-0555
2
Plaisir 1000
Installation Procedure
• Use liquid detergent & soft cloth to clean bathtub regularly.
• Do not use detergent containing acetone or ammonia. Also do not use abrasives or detergents
containing chemical solvent or solid particles; it could easily scratch.
• To repair scratches in the acrylic, use #1500 wet polishing sand paper to grind. Subsequently, use a
cloth with car wax to polish the scratch to obtain a glossy finishing.
• To remove joint compound, use a plastic or wood spatula wrapped with a damp cloth. Do not use any
metal tool or brush.
• If a rubber mat is used inside the tub, it is necessary to remove it after every bath. Otherwise, poten-
tial damage could be caused and will not be covered by warranty.
GENERAL TUB MAINTENANCE & REPAIR
CONGRATULATIONS!!!
Now your Tub should be ready for use! Enjoy your bath!
If you have any questions, feel free to contact us
at the Customer Service: 866-333-0555
DRAIN & OVERFLOW SYSTEM
PLEASE NOTE: The Drain & Overflow System is already
installed. The following illustration is for informational
purposes only.
3
12
6
7
48
9
11
12
10
DRAIN
13
1
2
OVERFLOW
X
TUB INSTALLATION
1) Prepare the piping to connect to the drain.
(Professional Installation Recommended)
2) Verify the fitting to connect the drain.
3) Once the pipe under the floor is ready put the
tub in place and connect underneath.
4) Remove the plastic drain
(part #10 shown in above
illustration)
usedfor
qualitycontrolonly. See
picture.
5) Proceed to finalise piping connections.