Jaymar D-BOX LIFESTYLE User manual

USER GUIDE
D-BOX LIFESTYLE Instructions

D-BOX LIFESTYLE Instrucons
CONGRATULATIONS, you have just received your Jaymar D-BOX LIFESTYLE!
Before to install your seat , Please read all instructions carefully before starting the assembly.
It is recommended using two adults throughout the process. Here is how to install your recliner back.
GET READY
Unpack the box - Remove all packaging from your seat.
You should have in your Jaymar Experience box: 1seat base, 1 seat back and hidden in the seat base,
your plastic bag with accessories.
A plastic bag with:
A1 x Power Cord
B1 x CAT.5E Shielded Cable 9.10 ft
C3 xStabilization Cups
D1 x IEC Plug-Lock insert
D
A
B
C
Your seat in 2 parts like (Back and seat):
No tools for assembly required.

STEP 1
Ensure that back clip is properly aligned with the anchoring of the base on both
sides. Slip the anchors into the clips and moving the back slightly back from left to right to
lower it and engage it.
Anchor
Clip

STEP 4
Insert the IEC Plug Lock (yellow block) on the male end of the power cord (black cable).
Connect the power cord to the back panel.
.

STEP 6
Place the flap inside the back using the velcro
STEP 5
You can now recline your D-BOX Lifestyle seat!

STEP 7
Install the three D-BOX Stabilization Cups (under foot). Lift one corner and slide the cupola under
the white tip of the actuator. Repeat for the second actuator and the rear pivot.
ACTUATORS
PIVOT
FRONT
BACK

IMPORTANT NOTICE
IMPORTANT , never move your furniture by sliding it on the floor. This could damage the
actuators or your floor. Never operate the D-BOX technology without the Stabilization cups.
INSTALLATION IN YOUR ROOM
Leave a clearance of 4'' between each D-BOX chair no tot block the range of motion.
If the chair is near a wall, allow 6'' of clearance.
Keep 6,5'' of wall clearance behind your seat and 20'' in front.
Please consult the D-BOX User Guide to set up your HaptiSync Hub.
!
4" 4"
6"
6,5"
65,75"
20"