Jimmy Styks IRONHIDE 330 User manual

OWNER’S GUIDE

2
FOR WARRANTY INFORMATION, PARTS/ACCESSORIES, CALL
1-800-370-0745 OR CONTACT US THROUGH OUR WEB SITE,
WWW.JIMMYSTYKS.COM
READ THIS IMPORTANT INFORMATION BEFORE USING
YOUR STANDUP PADDLEBOARD
DISREGARDING ANY OF THE SAFETY PRECAUTIONS AND INSTRUCTIONS CONTAINED IN THE OWNER’S MANUAL
AND/OR ON THE PRODUCT MAY RESULT IN INJURY, INCLUDINGTHE POSSIBILITY OF DEATH.
- JIMMY STYKSTM IRONHIDE 330 HAS A RECOMMENDED WEIGHT CAPACITY OF 230 LBS. BASED ON A NOVICE SKILL
LEVEL. FOR MORE INFORMATION REGARDING WEIGHTVS. SKILL LEVEL, VISIT
WWW.JIMMYSTYKS.COM.
- ALWAYSWEAR A COAST GUARD APPROVED PERSONAL FLOTATION DEVICE (PFD).
- NEVER GO PADDLEBOARDING IN SEVEREWEATHER OR WATER CONDITIONS THAT MIGHT AFFECT YOUR ABILITY
TO STEER THE BOARD OR RETURN TO SHORE.
- NEVER ALLOW MINORS TO USETHIS BOARD WITHOUT ADULT SUPERVISION.
- NEVER CONSUME ALCOHOL OR ANY OTHER SUBSTANCES THAT MAY IMPAIR YOUR COORDINATION, JUDGEMENT,
OR ABILITY TO SAFELY PADDLE THE BOARD.
- NEVER USE THIS BOARD BEYOND YOUR SKILLS OR ABILITY.
- NEVER USE THIS PRODUCT AFTER SUNSET, BEFORE DAWN OR AT ANY TIME IN POOR LIGHTING.
- CHECK LOCAL LAWS AND REGULATIONS REGARDING PROPER AND SAFE USE OF THIS PRODUCT.
- NEVER LEAVE BOARD EXPOSEDTO DIRECT SUNLIGHT WHEN OUT OFTHEWATER.
- DO NOT STORE PADDLEBOARD IN A WET BOARD BAG FOR EXTENDED PERIODS OF TIME.
- DO NOT LEAVE BOARD IN BAG UNDER DIRECT SUNLIGHT.
- REGISTER YOUR JIMMY STYKSTM PADDLEBOARD ONLINETO ACTIVATE PRODUCT WARRANTY.

S E C T I O N 1:
JIMMY STYKSTM IRONHIDE 330 OVERVIEW
S E C T I O N 2:
CARE AND MAINTENANCE
S E C T I O N 3:
JIMMY STYKSTM FINS
S E C T I O N 4:
JIMMY STYKSTM ADJUSTABLE PADDLES
S E C T I O N 5:
JIMMY STYKSTM LEASH
S E C T I O N 6:
TRANSPORTATION TIPS
SAFETY GUIDELINES
LIMITED WARRANTY INFORMATION
PAGES 4  5
PAGES 6  7
PAGES 8  9
PAGES 10  11
PAGE 12
PAGE 13
PAGE 14
PAGE 15
TABLE OF CONTENTS
3
QUESTIONS/COMMENTS:
1-800-370-0745

C.
B.
A.
D.
E.
4
FOR WARRANTY INFORMATION, PARTS/ACCESSORIES, CALL
1-800-370-0745 OR CONTACT US THROUGH OUR WEB SITE,
WWW.JIMMYSTYKS.COM
SECTION 1
JIMMY STYKSTM IRONHIDE 330 OVERVIEW
As the popularity of stand up paddleboarding
continues to venture into some of the most
remote corners of the world, so does the need
for a strong, durable board that can survive the
journey. The IRONHIDE SERIES is our answer
to that demand. Constructed of a sturdy
polyurethane core encased in shatter-resistant
polyethylene, the JIMMY STYKSTM IRONHIDE
SERIES can take a serious beating. Our IRONHIDE
products are virtually impervious to dings, cracks
and other damages that are commonplace among
traditional epoxy sups. The exceptional durability
of our IRONHIDE products are an excellent choice
for rugged environments, crowded waterways,
rentals, rst time paddlers and children.

5 ”
P
1 2 ’ 0 ” x 3 2 ” x
FISHING SU
blue heron
12 ’ 0 ” x 3 2 ” x 5 ”
TM
STANDUP PADDLEBOARD
BUNGEE TIES
TRACTION PAD
CARRY HANDLE
LEASH PLUG
FIN BOX
FIN SCREW AND PLATE
FIN KEY
STABILIZER FIN
LEASH
ADJUSTABLE PADDLE
A.
B.
C.
D.
E.
F.
G.
H.
I.
J.
K.
PACKAGED ITEMS MAY VARY BY RETAILER
F.
K.
1 1 ’ 0 ” x 3 1 ” x 4
3
/
4
”
SOFT SUP
TM
G.
I.
H.
J.
5
QUESTIONS/COMMENTS:
1-800-370-0745
10’10” x 32” x 4.625”

Directsunlight can result in delamination ofaboard ifleftexposedfora period oftime. Delamination is
characterized by a separation of the board’s core from the protective epoxy skin. Delamination
is a damage that is not repairable and should be avoided at all costs. Keep your board in an area
with good air ow and circulation. Leaving your board in a vehicle during the day (closed or
open) elevates the risk for delamination.
KEEP IN A WELL VENTILATED, SHADED
AREA WHEN NOT IN USE.
While the benets of a non-slip traction pad are obvious, they also increase the risk of overheating
and delamination. While in use, water owing over the deck helps to regulate surface temperature.
But when the deck traction pad is dry, the eects of heat absorption are amplied when exposed to
direct sunlight. If you must expose your board to direct sunlight during transport or temporary
storage, it is safest to keep the white (bottom) facing up.
LIMIT EXPOSURE OF DIRECT SUNLIGHT
TO THE DECKSIDE OF THE BOARD.
OVERHEATING YOUR PADDLEBOARD
IS NOT COVERED BY THE
MANUFACTURER’S WARRANTY!
SECTION 2
6
FOR WARRANTY INFORMATION, PARTS/ACCESSORIES, CALL
1-800-370-0745 OR CONTACT US THROUGH OUR WEB SITE,
WWW.JIMMYSTYKS.COM
CARE & MAINTENANCE

DO NOT STORE YOUR BOARD IN A BOARD
BAG FOR EXTENDED PERIODS OF TIME.
Board bags are intended for transportation protection, not full time storage. Prolonged storage of a wet board
in a wet board bag will have adverse eects on the nish of your board, leading to the possibility of mold, and
osmotic blisters. Storing your board in a board bag is not the same as placing it in the shade. Board bags will
collect heat and potentially overheat your board.
RINSE SAND AND SALTWATER DEPOSITS
FROM YOUR BOARD AFTER USE.
Sun, sand and saltwater will degrade any man-made material over time. Rinse o sand and saltwater deposits
from your paddleboard with fresh water and store in a cool, dry environment after each use.
INSPECT YOUR BOARD FOR DINGS AND
CRACKS BEFORE AND AFTER EACH USE.
To prevent your board from becoming waterlogged (heaviness and drag as a result of water absorption), regularly
inspect the exterior for dings and cracks. If you spot a crack, patching with epoxy is the preferred method of
repair. Jimmy StyksTM boards use minimal colored paints/decals in areas prone to damage so repairs can be made
with minimal aesthetic disruption.
7
QUESTIONS/COMMENTS:
1-800-370-0745

Keep your ns in good condition by removing them after each use. Damage to the n incurred while attached
to the paddleboard may result in severe damage to the n box, the watertight skin and the foam core. Attach
the n rmly before you go riding.
STABILIZER FIN INSTALLATION/REMOVAL
8
FOR WARRANTY INFORMATION, PARTS/ACCESSORIES, CALL
1-800-370-0745 OR CONTACT US THROUGH OUR WEB SITE,
WWW.JIMMYSTYKS.COM
SECTION 3
INSERT SCREW PLATE INTO FIN BOX SLOT AND SLIDE PLATE FORWARD
STEP 1
INSERT FIN INTO FIN BOX SLOT
STEP 2
JIMMY STYKSTM FINS

REMOVAL PROCEDURE
REVERSE STEPS 5 THROUGH 1.
ROTATE FIN FORWARD AND ALIGN FIN SCREW WITH SCREW PLATE
STEP 3
screw p
l
at
e
LOOSELY TURN FIN SCREW INTO SCREW PLATE
STEP 4
ADJUST FIN TO DESIRED POSITION AND TIGHTEN FIN SCREW.
STEP 5
9
QUESTIONS/COMMENTS:
1-800-370-0745

10
FOR WARRANTY INFORMATION, PARTS/ACCESSORIES, CALL
1-800-370-0745 OR CONTACT US THROUGH OUR WEB SITE,
WWW.JIMMYSTYKS.COM
JIMMY STYKSTM ADJUSTABLE PADDLES
SECTION 4
MAX.
EXTENSION
24 IN.
(61 CM)
Extending beyond the maximum extension limit can result in
permanent damage to the adjustment clip while paddling.
We recommend paddle to be rinsed with fresh water after
every use and upper shaft removed for drying.
Do not leave exposed to direct sunlight for prolonged periods.
The sun can damage the epoxy and nish of the paddle.
DO NOT EXTEND UPPER
SHAFT BEYOND
24 IN (61CM).
PROPER HEIGHT ADJUSTMENT FOR
JS ADJUSTABLE PADDLES
TM
8 - 10 IN. (20.3 CM - 25.4 CM)