JLL R200 User manual

If you have any further queries please contact
our customer service team on 0121 328 7507
or email at ‘contact@jllfitness.co.uk’
R200 MONITOR INSTRUCTIONS
If your monitor is not displaying any readings some things to check are;
1. The wires behind the monitor are connected
2. The sensor underneath the slideway is attached securely
W hen replacing the
batteries make sure they
are the correct way round
Remove the black tape to
replace the batteries
To remove the monitor
push up the small clip
at the bottom
The monitor will
automatically be in ‘SCAN’
mode
Press the single button on
the monitor to exit ‘SCAN’
mode, continuously press until
the arrow corresponds to the
correct setting
Press and hold the single
button to reset the
monitor back to zero
1. SET UP
2. BASICS
3. TROUBLESHOOT

Total Count: The total number of rows since the machine has first been used.
Distance: The total accumulated distance, in kilometres during your workout.
Calorie: The total accumulated calories burned during your workout.
Count/Min: Calculates the average number of rows you will complete within a minute.
Time: The total time you have been exercising. Display time as hours: minutes.
Scan: This function will continuously change between each setting, displaying one after the other every
few seconds.few seconds.
Count: The number of rows completed during your workout.
4. DATA READOUTS