JMK URZ0123 User manual

User’s Manual
DOME CAMERA
Before you use this product,please read the introduction
Ä ¿ µ × ³
É ¼£ É º£
Ò Î£
Å ×£
ÁÔ»
Í ¸£ ÑÉ£
³ ´£
ÎÁ±Â£
μ±º£
²Æó£
² Ö£ Ò´:1/2
°´:1.0
CUM-JMK-JK901CD
ÓÎJK-901CDËÃÊ
槐
157gÍ°Ö
200(L)X148.5(H)mm
¸ º£
1
2
3
4
5
6
1
2
3
4
5
6
AB C D
AB C D
иÇÓ Ã Ê È Æ µ µ
XXXXXXXXXXXXXX XXXXXXXX XXXXXX
1
MODEL NO:JK-901CD
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:TO REDUCE ANY RISK OF ELECTRIC SHOCK,DO NOT REMOVE COVER(OR BACK),NO
SERVICEABLE PARTS INSIDE.REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
The lighting flash with arrowhead symbol , within an equilateral triangle,is interned to alert the presence of
uninsulated’ dangerous voltage’ within the product’s enclosure that may be of sufficient risk of electric
shock for persons.
The exclamation point within an equilateral triangle is intended to alert the presence of important operating
and maintenance (servicing) instructions in the literature accompanying the appliance
WARNING:TO PREVENT FIRE OR SHOCK HAZARD,DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
Notes on Installation and usage
1.Do not attempt to disassemble the camera
To prevent from electric shock,do not remove screws or cover, There are no serviceable parts
inside. Ask a qualified service person for servicing.
2.handle the camera with care
Do not abuse the camera.Avoid striking,shaking,etc,the camera could be damaged by improper
handling or storage.
3.Do not expose the camera to rain or moisture or try to operate it in wet areas
Turn the power off immediately and ask a qualified service person for servicing,Moisture can
damage the camera and also create the danger of electric shock
4.Do not use strong or abrasive detergents when cleaning the camera body
Use a dry cloth to clean the camera when dirty.In case the dirt is hard to remove,use a mild detergent
and wipe gently.
5. Clean the CCD faceplate with care
Do not clean the CCD with strong or abrasive detergents.Use lens tissue or a cotton tipped applicator
and ethanol.
6.Never face the camera towards the sun
whether the camera is in use or not.Never face it towards the sun or other extremely bright objects.
Otherwise,blooming or smear may be caused.
7.Do not operate the camera beyond the specified temperature,humindity
Use the camera under conditions where temperature is -10¡-+50¡and humidity is below 90%
8.The camera should be operated only from the type of power source indicated on the marking
label
Side:A
URZ0123

COLOR CCD CAMERA
Image Sensor
Signal System
542(H) ¡492(V)270K 542(H) ¡582(V)320K
512(H) ¡492(V)250K 512(H) ¡582(V)290K
420TV Lines
15.734KHz(H)/59.94Hz(V) 15.625KHz(H)/50Hz(V)
Internal
2:1 Interlace
Composite: 1.0Vp-p,75¦,Unbalanced
1/60~1/100,000sec Auto 1/50~1/100,000sec Auto
0.45
More than 48db(AGC off)
1.0Lux
Auto
DC12V
NTSC PAL
Total Pixels Number
Effective Pixels Number
Horizontal Resolution
Scanning Frequency
Sync.System
Scanning System
Video Output Level
Electronic Shutter
Gamma Correction
S/N Ratio
Minimum illumination
White Balance
Supplied Voltage
1/3¡1/4¡SHARP CCD
Ä ¿ µ × ³
É ¼£ É º£
Ò Î£
Å ×£
ÁÔ»
Í ¸£ ÑÉ£
³ ´£
ÎÁ±Â£
μ±º£
²Æó£
² Ö£ Ò´:2/2
°´:1.0
CUM-JMK-JK901CD
槐
157gÍ°Ö
200(L)X148.5(H)mm
¸ º£
1
2
3
4
5
6
1
2
3
4
5
6
AB C D
AB C D
иÇÓ Ã Ê È Æ µ µ
XXXXXXXXXXXXXX XXXXXXXX XXXXXX
1
Dome Camera Installation
1.Hold the camera body with one hand press the theft proof
lock and turn the dome clockwise to remove it with other
hand, in order todisassemble it.
2.Attach the camera body on the target location with the
screwdriver using the provided tab screw.
3.Adjust the pan angle by loosing the tab screws and rotate
the camera body,and then fasten the screws.
4.Loosen the focus fix screw on the lens holder of the
camera,adjust the lens focus until you can see the image
clear , and then tighten the focus fix screw.
5.Adjust the tilt angle of camera by loosing the screw on
the bracket and moving the bracket inside the dome
camera upward or downward.Make the lens most close
to the dome transparent cover. And then fasten the screw.
6.Assemble the dome cover by turning it counterclockwise.
Theft proof lock
The screw
Wall of ceiling
The screw
Focus fix
screw screw on the bracket
EXAMPLES OF CONNECTIONS
1.one monitor system with one camera.
VIDEO
POWER
AC ADAPTER
MONITOR
CAMERA
2.One monitor system with two or more cameras.
MONITOR
SEQUENTIAL SWITCHER
OR QUAD SPLITER
VIDEO
POWER
AC ADAPTER
VIDEO
POWER
AC ADAPTER
VIDEO
POWER
AC ADAPTER
CAMERA
CAMERA
CAMERA
EXAMPLES OF CONNECTIONS
Side:B
ÓÎJK-901CDËÃÊ