Thank you for your purchase of Finishing Touch® Flawless®, the easy and convenient facial hair remover.
Installing / Changing Battery
• Remove the Finishing Touch® Flawless® cap (Image 1).
• Grab the upper section of the unit with one hand, the bottom half with the
other, and pull apart (Image 2) to reveal the battery chamber.
• Place 1x 1.5V AA alkaline battery (not included) into the compartment, making
sure the positive pole (+) is facing the bottom of the unit.
• Slide/snap the unit’s bottom casing back into place (Image 2).
Battery Safety and Information
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are only to be charged under adult supervision.
• Rechargeable batteries are to be removed from the product before being charged
dierent types of batteries or new and used batteries are not to be mixed.
• Batteries are to be inserted with the correct polarity.
• Always make sure the battery compartment is secure.
• Exhausted batteries are to be removed from Finishing Touch® Flawless®.
• The supply terminals are not to be short-circuited.
How to Use
• Remove the Finishing Touch® Flawless® cap (Image 1).
• Slide the switch located on the side of the unit upward into the “ON”position
(Image 3). The light will automatically turn on when the unit is“ON”.
• Gently press the head of the unit at against your skin. The unit should not be on an
angle. Proceed making small circular motions to remove unwanted hair (Image 5).
NOTE: It is normal for the head to become warm with use.
Cleaning (be sure unit is o)
• Twist the rotating hair removal head counter-clockwise and lift o (Image 4).
• After each use, clean the head by using a brush (included) to wipe away the hair residue.
• Empty any hair from the body of the Finishing Touch® Flawless® unit by turning
it over and gently tapping the sides.
• To put the hair removal head back on the unit, line up the“groove”indicators on
the cap with those on the unit and twist clockwise (Image 4).
Tips & Pointers
• For superior results, use on hair ¼" in length or less.
• If the unit begins to slow down, clear the hair removal head and body of any hair
residue. If the unit is still running slow change the battery.
• Gentle enough to use every day.
• For airbrush-like make-up application, use daily.
NOTE: Prior to rst use, test the Finishing Touch® Flawless® on a small area. If any
sensitivity or allergic reactions occur, discontinue use immediately. Do not use
your Finishing Touch® Flawless® on sensitive or irritated skin.
Replacement Head
For optimal results it is recommended that you replace your Finishing Touch®
Flawless® head every 6 months. The head may need to be replaced sooner if the
Finishing Touch® Flawless® loses performance or if the head becomes chipped or
damaged in any way. Please contact JML customer services for replacement heads.
IMAGE 1
IMAGE 3
IMAGE 5
IMAGE 2
IMAGE 4
Warnings
• Keep out of reach of children.
• This is not a toy. Children shall not play with this product.
• Do not use on irritated skin. Discontinue use if skin
irritation occurs.
• Do not use on sensitive eye areas. Do not use on eyelashes.
• Avoid direct eye exposure. Do not look directly into light
during use.
• Do not rinse trimmer head under water.
• Do not submerge unit under water.
• Store in a cool dry place when not in use.
