JONATHAN Y JYL9054A User manual

WARNING
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR
OBVIOUS DEFECT, DO NOT INSTALL. ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
CARE AND MAINTENANCE
Model# JYL9054A
Product Dimensions: Ø15.75 X 62.5"H
Unplug lamps before using any cleaning solutions. Dust shades with a feather duster or with an appropriate
vacuum-brush attachment. Wipe with a soft, dry cloth and clean lamp bases with the methods appropriate to
the material. Avoid the use of chemicals and household cleaners as they may damage the finish.
NOTICE& IMPORTANT SAFETY INSTRUCTIONS
* Please make sure that you have all parts indicated before you begin assembly of this item
* This item should be assembled on a soft surface to prevent scratching the finish during assembly
* To reduce the risk of fire, electrical shock or injury to persons or property, please follow the guideline below
for safe use and installation
*The external flexible cable or cord of this lamp cannot be replaced;
If the cord is damaged, the lamp shall be destroyed
**This portable lamp has a polarized plug (one blade is wider than the other) as a safety feature to reduce
the risk of electric shock. this plug will fit in a polarized outlet only one way. if the plug does not fit fully in
the outlet, reverse the plug, if it still does not fit, contact a qualified electrician. Never use with an extension
cord unless the plug can be fully inserted. do not attempt to disgard this safety feature.
Part List and Hardware List
1X
PIECE DESCRIPTION PICTURE QUANTITY
C
Body Frame
Tube w/t teeth
B
A
1X
2X
3X
EBulb
32X+1X
PIECE DESCRIPTION PICTURE QUANTITY
DBase
Tube with teeth FCrystal Strip
1X

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware
contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 6 minutes.
PLEASUE USE TYPE"B" BULB MAX 40-WATT OR CFL BULB MAX 13-WATT OR LED MAX 9-WATT
THERE ARE 3 X 4W LED BULBS IN THE BOX.
Step 1 Step 2 Step 3
Make sure all parts could be aligned before assemble Hang each Crystal Strip(E) onto the Body
Frame(A).
Put the light on a level surface to check
Do not rotate lamp body too hard avoid base screw broken Insert the bulb(D) into the socket. if everything is stable.
Insert the Tube with teetch(C) into the Base(D).
Insert the Tube with teetch(C) into the Tube with teetch(C).
Insert the Tube w/t teetch(B) into the Tube with teetch(C).
Insert the bottom nipple of the Body Frame (A) into the Tube
w/t teeth(B).
Be careful not to twist the power cord and tighten securely
ENJOY YOUR LAMP
1
2
3
A
B
D
C
C
EF