MODE Button:
•Press “MODE” button once to switch between the time and alarm mode.
•Press and hold “MODE” button for seconds to enter setting mode.
UP Button:
•Press “UP” button once, to display Outdoor temperature CH1 CH2 CH3.
•Press and hold “UP” button for a few seconds, to refresh display of Outdoor temperature.
DOWN Button:
•Press “DOWN” button once to switch between °C/°F (Celsius & Fahrenheit) temperature display.
MAX/MIN Button:
•Press “MAX/MIN” button once to check the maximum and minimum of temperature and humidity.
SNZ Button:
•SNZ stands for Snooze. Press “SNZ” button to snooze the alarm. Default snooze duration is 5 minutes. It can be
adjusted anywhere between 1 and 20 minutes.
•Pressing “SNZ” button also turns on the display backlight.
•“SNZ” and “Light/SNZ” buttons have same functions.
A. TIME (Default time format shown 24HR)
•Press and hold “MODE” button for seconds to enter the Time setting mode.
•Setting format: year month date 12/24HR hour minute exit.
•Default calendar at 0:00, January 01, 2008
•Press “MODE” button once to confirm and go to the next setting.
•Press “UP” button once to increase value slightly. Press and hold “UP” button for seconds to increase value rapidly.
•Press “DOWN” button once to decrease value slightly. Press and hold “DOWN” button for seconds to decrease value
rapidly.
•Moon Phase and Week Display updates as per calendar setting.
B. ALARM (Default alarm at 7:00)
•Press “MODE” button once to switch between the Display & Alarm mode.
•Press “UP” button once to activate the alarm function with (((•))) icon, and press the button once again to deactivate
the alarm function.
•Press and hold “MODE” button for seconds to enter the Alarm setting mode.
•Setting format: hour minute SNZ time. [Default SNZ time: 5 minutes] (You can select 1-20 minutes)
•Press “UP” button once to increase value slightly. Press and hold “UP” button for seconds to increase value rapidly.
•Press “DOWN” button once to decrease value slightly. Press and hold “DOWN” button for seconds to decrease value
rapidly.
•Press “MODE” button once to confirm the alarm setting time.
Buzzer sound of the alarm:
•0-10 seconds: BEEP 1 time per second
•10-20 seconds: BEEP 2 times per second
•20-30 seconds: BEEP 4 times per second
•After 30 seconds: serial BEEP
During BEEP, press “SNZ” or “LIGHT/SNZ” button once to repeat the alarm again in preset SNZ time later, or press
any other button to off the alarm.
The preset alarm time will remain valid on the following days as well.
C. TEMPERATURE ALERT (Default format shown °C)
Indoor temperature range: -9.9°C to +50°C
Indoor humidity range: 20% - 95%
Scanning time: +/- 30 seconds
Temperature not display when alarm goes off.
3
