JUMPtec TM-1406 Maintenance manual

14ft (426cm) Round Trampoline
84-0262 (TM-1406)
Assembly, Installation, Care, Maintenance and Use Instructions
Manual depicts typical installation – your model may differ from illustrations
Toll Free Helpline: 1-866-567-4089
WARNING
Please read and retain this manual as it will assist with identification for parts and service.
Read these materials prior to assembling and using of this product
Page: 1 (Version 2)
- WARNING -
This trampoline is subject to 113kgs weight limit.
Usage of this trampoline is limited to persons weighing less than weight specified above.
Do not allow more than one person on the trampoline at a time. Use by more than one
person at the same time can result in serious injury.
Do not allow young children to use unless supervised by an adult.

Page: 2 (Version 2)
Contents
ASSEMBLYAND INSTALLATION INSTRUCTIONS..............................................3
PARTS LIST – TRAMPOLINE.....................................................................................4
EXPLODED VIEWTRAMPOLINE ASSEMBLY........................................................5
TRAMPOLINE ASSEMBLY........................................................................................6
Frame Assembly.............................................................................................................6
Mat Assembly ................................................................................................................7
Frame Pad Assembly......................................................................................................9
CARE & MAINTENANCE INSTRUCTIONS...........................................................12
DISPOSAL INFORMATION......................................................................................12
SAFETY PRECAUTIONS..........................................................................................13
FUNDAMENTAL TRAMPOLINE SKILLS ..............................................................15
JUMPERS’ROLE IN PREVENTING ACCIDENTS.................................................22
SUPERVISORS’ ROLE IN PREVENTING ACCIDENTS........................................22
LIMITED WARRANTY .............................................................................................23

ASSEMBLYAND INSTALLATION INSTRUCTIONS
WARNING
zAdequate overhead clearance is essential. A minimum of 24ft (8m) from ground
level is recommended. Provide clearance for wires, tree limbs, and other possible
hazards.
zLateral clearance is essential. Place the trampoline away from walls, structures,
fences, and other play areas. Maintain a clear space on all sides of the
trampoline.
zPlace the trampoline on a level surface before use.
zUse the trampoline in a well-lighted area.Artificial illumination may be required
for indoor or shady areas.
zSecure the trampoline against unauthorized and unsupervised use.
zRemove any obstructions from beneath the trampoline.
zThe owner and supervisors of the trampoline are responsible to make all users
aware of practices specified in the use instructions.
Page: 3 (Version 2)

PARTS LIST – TRAMPOLINE
Parts Supplied
Item Ref Description Illustration Qty
1 14TM-1 Mat with Sewn-in
V-Rings
1
2 14TM-2B Frame Pad 2
3 14TM-3 Vertical Leg Tube
12
4 14TM-4 W-Shape Leg Tube 6
5 14TM-5 Top Rail Tube 12
6 14TM-6 T-Joint 12
7 14TM-7 Springs 84
11 14TM-11 Locking Pins
(Pre-installed in Vertical
Leg Tubes & W-Shape Leg
Tubes)
24
Use the Parts List to ensure all parts are present.
Contact Customer Service at 1-866-567-4089 if any parts are missing.
Do not attempt to assemble the trampoline if any parts are missing.
Page: 4 (Version 2)

EXPLODED VIEW
84-0262 (TM-1406) 14FT ROUND TRAMPOLINE
Page: 5 (Version 2)

TRAMPOLINE ASSEMBLY
Frame Assembly
1. Lay out the parts on a clear dry
surface as shown in Figure 1.
2. To complete the Legs assembly.
Connect the Vertical Leg Tubes (3)
with the W-Shape Leg Tube (4) as
shown in Figure 2.
3. Connect the top rail tube (5) by
sliding the BIGGER END to the
T-Joint (6) first, then slide the
SMALLER END to form the top rail
loop. After sliding both ends to the
T-Joint, push a bit the top rail tubes to
make sure they stay firm with the
T-Joint. Please see Figure 3.
4. Join the completed Leg Tubes to the
Top Rail Loop as shown in Figure 4.
Page: 6 (Version 2)

5. Once completed, the skeleton of the
Trampoline should look like the
Figure 5.
MatAssembly
To facilitate the assembly of the springs to the mat, please use the Spring Hook
provided to pull the springs during assembly.
1. Spread out the Mat (1) and have both
the Springs (7) and Spring Hook ready
for assembly as shown in Figure 1.
2. Divide the Mat into halves and then
connect the first set of Springs (7) as
shown in Figure 2.
Page: 7 (Version 2)

3. Divide the Mat in to quarters and
connect the springs as shown in
Figure 3.
4. Divide the Mat into eighths and
connect the springs as shown in
Figure 4.
5. Connect the remaining springs to the
mat as shown in Figure 5.
6. When the Springs have been properly
connected, the trampoline should look
like Figure 6.
Page: 8 (Version 2)

Frame Pad Assembly
1. Lay out the Frame Pad on a dry and
clean surface.
2. Tie the two Frame Pads (2) together by
the sewn-in tie down straps on the
Frame Pads.
3. Place the Frame Pad on top of the
trampoline.
4. Align the pre-sewn straps to each
T-joint as shown in Fig 4.
Page: 9 (Version 2)

5. Secure the pre-sewn straps around
the T-joint with a knot as shown in
Fig 5.
6. Thread the straps through the
sewn-in strap hook under the pad and
the closest v-ring. Tie knots and
secure the Frame Pad as shown in
Fig 6.
7. The recommended Safe Play Area
is to be 250cm (2.5 meters)
beyond the trampoline on all
sides and 700cm (7metres) above
the top.
The Safe Play Area must be on level ground, free from all structures,
landscaping, trees and branches, rocks, wires, sprinkler heads and
other obstacles. Children can be seriously injured running or
colliding into such obstacles.
Page: 10 (Version 2)