1. ①Place your finger at the
indent of the stand located
at the bottom of this unit.
② Move your finger in the
direction of the arrow.
0514TOH-SW-VM
Using the Built-in Tilt Stand
You can use the stand to place the camera on the floor or table
to shoot from a low angle or when taking a selfie.
3. Tilt the stand as shown in the figure.
2. ①Lift the stand upright.
② Slide the stand in the
direction of the arrow to the
position indicated by the
line in the figure.
■ Storing the stand
①Lift the stand upright and slide
it in the direction of the arrow.
②Align the marks on the camera
and the stand.
③Flip the stand down to store.
If the stand is detached, reattach the stand immediately as instructed in the
Detailed User Guide to avoid losing it or accidentally swallowing it.
Caution
C4G
B5H-0029-00
Complete
Figure
・The front edge of the stand lifts
up.
If the stand does not move, do
not force it. Proceed to step 3.
・
Place the camera as shown in the
complete figure.
・
Dtailed User Guide: http://manual3.jvckenwood.com/c4g/ah/
C4G_stand-3レイアウト変更_A5_英語.indd 1 2014/05/29 14:27:27
