jWIN JX-CD427D User manual

Portable CD Player with AM/FM Radio V10M10_IM_EN_06022009
www.jWIN.com
Portable CD player with AM / FM Radio
Instruction Manual
JX-CD427/JX-CD427D
Please read this manual carefully before operating and save it for future reference.
Have a question? Please visit http://www.jWIN.com

Portable CD Player with AM/FM Radio V10M10_IM_EN_06022009
www.jWIN.com
INTRODUCTION
Thank you for purchasing the JX-CD427. Unpack the unit and make sure to put aside all
accessories so they will not be lost. We recommend that you retain the original carton and
packaging materials for future use, should you transport or ship the unit in the future.
Portable CD player with AM/FM radio
•20-track programmable memory
•Repeat–track (One / All) function
•Skip and search functions
•2-digit LED display
•Integrated AM / FM radio
•Playable media: CD / CD-R / CR-RW
•3.5mm Aux. in jack
What’s included
•Detachable power cord
•Warranty card

Portable CD Player with AM/FM Radio V10M10_IM_EN_06022009
www.jWIN.com
LOCATION OF CONTROLS
1. FM ANTENNA 8. PLAY / PAUSE BUTTON
2. HANDLE 9. SKIP / SEARCH BUTTONS
3. CD DOOR 10. VOLUME CONTROL KNOB
4. REPEAT BUTTON 11. AUX IN JACK
5. PROGRAM BUTTON 12. FUNCTION SWITCH
6. LED SCREEN 13. SPEAKERS
7. STOP BUTTON 14. TUNING KNOB
1 2 3
4 5 6 7 8
9
11 12 13 14
10

Portable CD Player with AM/FM Radio V10M10_IM_EN_06022009
www.jWIN.com
GETTING STARTED
AC Operation
Before operating the JX-CD427, make sure that the voltage on the unit corresponds to the
voltage of your local area. Unravel the AC Line Cord; insert one end into an AC socket on the
unit and the other end into a standard AC outlet.
1. In case of malfunction due to electrostatic discharge (ESD), reset the unit by
reconnecting the AC cord again to resume to normal operation.
2. When not in use, unplug the AC power cord from the AC power socket.
ÂThe mains plug is used as disconnect device, the disconnect device shall remain readily
operable.
Note: For JX-CD427D (dual voltage version), please switch to available voltage using the
switch in the battery compartment.
Battery Operation
Disconnect the AC Cord. Open the BATTERY compartment and insert 6 x “C” or UM2 batteries
(not included) making sure that the battery polarity (+/-) is observed.
Remove the batteries if the unit will not be used for a long period of time.
Antenna
For best FM reception, fully extend the FM ANTENNA. For AM reception, the unit has a built-in
antenna, relocate or turn the whole unit for best reception.

Portable CD Player with AM/FM Radio V10M10_IM_EN_06022009
www.jWIN.com
OPERATING INSTRUCTIONS
Listening to the Radio
Slide the FUNCTION SWITCH to AM or FM position. Turn the TUNING KNOB to your desired
radio station. Adjust the sound level by rotating the VOLUME CONTROL KNOB. To turn off the
radio, simply slide the FUNCTION SWITCH to POWER OFF position.
Note: Radio frequency is shown on the TUNING KNOB.
Listening to CDs
Open the CD DOOR. Place a CD disc into the CD compartment and close the CD DOOR. Set
the FUNCTION SWITCH to the CD/AUX position. Adjust the sound level by rotating the
VOLUME CONTROL KNOB. Follow the Operational Instructions in the following pages of this
manual.
Note: Before playing a CD make sure the CD DOOR is properly closed.
Audio CD Playback
1. When the CD DOOR is closed and a CD is inside, the total
number of the tracks in the disc show on the LED SCREEN.
2. If there has no disc inside, the LED SCREEN will display
“” and remain in Stop mode.
3. If the CD DOOR is not closed, the LED SCREEN will
display ”00”.
PLAY/PAUSE MODE
1. When the PLAY/PAUSE button is pressed during CD stop
mode, the first track will play. The PLAY/PAUSE/PROG
indicator will light. The LED SCREEN will also display the
number of the currently playing track.
2. For interruption while the CD is playing, press the CD
PLAY/PAUSE button once. Playback is now paused and the
track number will blink continuously on the LED SCREEN.
3. Though the sound stops, the disc will continue to spin. To re-
start playback, press the PLAY/PAUSE button again. The music
will start from the exact position where it was paused.

Portable CD Player with AM/FM Radio V10M10_IM_EN_06022009
www.jWIN.com
4. To stop the CD, press the STOP button once in Play or Pause mode. The LED SCREEN
will show the total number of tracks on the disc again.
5. To turn off the unit, slide the FUNCTION SWITCH to POWER OFF position.
OPERATING INSTRUCTIONS
Audio CD Playback-continued
SKIP AND SEARCH MODE
1. In play or pause mode, when the SKIP/SEARCH buttons are pressed once, the player
will advance to the next track or return to the beginning of the track.
2. During play mode, when the SKIP/SEARCH button are pressed and held, it will search
the track with audible high-speed forward or backward playback.
REPEAT MODE
1. Repeat 1:
When the REPEAT button is pressed once, the REPEAT indicator
light will blink continuously. This single track of music will be repeated.
2. Repeat All:
When the REPEAT button is pressed twice, the REPEAT indicator
light will light. The whole disc will be played continuously.
3. To cancel the Repeat Function
Press the REPEAT button repeatedly until the REPEAT Indicator light
disappears.
PROGRAM MODE
1. During the CD stop mode, press the PROGRAM button once. The
PLAY/PROGRAM indicator light and the number of the program to be
memorized starts from the first program “01” will blink continuously on
the LED SCREEN.
2. Press the SKIP/SEARCH buttons to your desired musical track, the
LED SCREEN will show the appropriate track number. Press the
PROGRAM button to store this track in memory.
3. Repeat the above procedure until all desired tracks have been programmed. A total of
20 tracks can be stored in memory.
Note: When the SKIP/SEARCH buttons are pressed, it will always show the last
programmed track first to recall your memory.
4. Press the PLAY/PAUSE button once to start the program playback
and the CD play (PLAY/PAUSE/PROG) Indicator light will blink
continuously
5. To check the program you have stored after complete programming,
press the PROGRAM button once during CD stop mode. The LED
SCREEN will show the programmed tracks in order. Repeat above
procedure to read all the programmed memory.

Portable CD Player with AM/FM Radio V10M10_IM_EN_06022009
www.jWIN.com
6. To cancel the programmed memory:
•During the CD stop mode, press the STOP button once, or
•Open the CD DOOR during the CD stop mode.
The PLAY/PAUSE/PROG Indicator light will disappear.
OPERATING INSTRUCTIONS
Auxiliary (AUX) Mode
1. Slide the FUNCTION SWITCH to the CD/AUX position.
2. Connect the earphone socket from the Auxiliary unit (e.g. MP3 player or MD player) into
AUX-IN jack on the side of this product via an Audio Line Cord (3.5mm plug on both
ends; not supplied).
3. Play the Auxiliary unit. Music from the Auxiliary unit can be listened through the speaker
of this product.
Note: Make sure the volume level on the auxiliary unit is set high. CDs will NOT play when the
Audio Line Cord is plugged in.
Maintenance
Notes on CDs
1. Before playing, clean the CD with a cleaning cloth.
Wipe the CD from the center out to the ends.
2. Do not use solvents such as benzine, thinner,
commercially available cleaners or anti-static spray
intended for vinyl LPs.
3. Do not expose the CD to direct sunlight or heat sources such as hot air ducts. Do not
expose to direct sunlight, nor leave CDs in a car, as there can be a considerable rise in
temperature.
4. Do not stick paper or sticker on the CD. Do not scratch, dirt or fingerprints on the CD, for
it may cause tracking error.
Cleaning the lens
If the lens becomes dirty, it may cause a skipping of sound during CD operation. Clean with a
commercially available lens cleaner.
Cleaning the cabinet
Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent
solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as alcohol or
benzine.

Portable CD Player with AM/FM Radio V10M10_IM_EN_06022009
www.jWIN.com
TROUBLESHOOTING GUIDE AND SPECIFICATIONS
When the instructions in this manual are followed, this unit should function properly. However, if
any of the following difficulties occur and cannot be corrected by the user or if a problem arises
that is not mentioned here, please contact jWIN Customer Service or a qualified service
technician.
1. Unit Does Not Play
•Unit may be disconnected from power source (No AC connection or batteries). Check
connection.
•Disc is not correctly set. CDs should be inserted label side up.
•Disc is scratched or dirty. Please clean.
•The lens is dirty. Wipe clean gently with soft, dry cloth. Follow the instructions of the
lens cleaner.
•There is moisture on the lens wait an hour and try again.
2. No Sound, Distorted Sound or Feedback
•Ensure plugs are inserted firmly.
•Wipe off plugs with clean cloth.
•Disc is scratched or dirty. Please clean.
•Volume control is turned down. Please increase.
3. Radio Reception is Unclear
•Radio station frequency may be weak. Adjust antenna.
Specifications
•Audio Output: 0.8WRMS(L) + 0.8WRMS(R)
Total: 1.6WRMS / 3.0WPEAK / 30WPMPO
•Connectivity
o3.5mm Aux. in jack
oPower input jack
•Power Requirement
oJX-CD427: AC 120V, 60Hz (USA, Canada)
oJX-CD427D: AC 110V / 220V, 60Hz / 50Hz (International)
oBattery: 9V (6 x “C” or “UM2” batteries, not included)
•Power Consumption: ≤15W
•Unit Dimensions (W x H x D): 10.1” x 5.0” x 11.9” (257mm x 126mm x 230mm)
•Unit Weight: 2.7 lbs (1.2 kg)
* Specifications and features are subject to change without prior notice.

Portable CD Player with AM/FM Radio V10M10_IM_EN_06022009
www.jWIN.com
USER SAFETY GIUDE
IMPORTANT SAFETY INSTRUCTIONS
WARNING: To prevent fire or shock hazard, do not expose this appliance to rain or moisture.
These markings are located on the bottom, side or back of the unit.
CAUTION: To prevent the risk of electric shock, do not remove cover (or back). Non- user-
serviceable parts inside. Refer servicing to a service professional.
•The lightning flash with an arrowhead symbol, within an equilateral triangle, is intended to
alert the user to the presence of un-insulated "dangerous voltage" within the product's
enclosure that may be of sufficient magnitude to constitute a risk of electric shock to a
person.
•The exclamation point within an equilateral triangle is intended to alert the user to the
presence of important operating, maintenance and servicing instructions in the literature
accompanying the appliance.
Dripping warning: "This product shall not be exposed to any dripping or splashing, and no
objects filled with liquids, such as vases, shall be placed on or near the product."
Ventilation warning: "The normal ventilation of the product shall not be impeded for intended
use." (Minimum distances must be kept around the apparatus for sufficient ventilation,
especially while use of the apparatus is in tropical and/or moderate climates.)
Dispose of old batteries safely. Do not throw them into a fire.
LASER SAFETY
This unit utilizes laser technology. Only a qualified professional should
remove the cover or attempt to service this device, due to possible eye
injury.
CAUTION
•Use of controls or adjustments or performance of procedure other than
specified herein may result in hazardous radiation exposure.
•Hazardous laser radiation when open and interlock defeated.
DANGER
Invisible laser radiation when open and interlock failure. Avoid direct

Portable CD Player with AM/FM Radio V10M10_IM_EN_06022009
www.jWIN.com
exposure to beam.
USER SAFETY GIUDE
INSTRUCTIONS ON ENVIRONMENT PROTECTION
Do not dispose of this product in the usual household garbage at the end of its
life cycle; bring it to a collection point for the recycling of electrical and electronic
appliances. This symbol on the product means the instructions for use or the
packing will inform about the methods for disposal. The materials are recyclable
as mentioned in its marking. By recycling, material recycling, or other forms of
re-utilization of old appliances, you make an important contribution to protect the environment.
Please inquire at your local community administration for the authorized disposal location.
IMPORTANT SAFETY PRECAUTIONS
1. READ INSTRUCTIONS - All safety and operating instructions should be read before the
appliance is operated.
2. RETAIN INSTRUCTIONS - The safety and operating instructions should be retained in a
secure place for future reference.
3. HEED WARNINGS - All warnings on the appliance and in the operating instructions should
be observed.
4. FOLLOW INSTRUCTIONS - All operating and use instructions should be followed.
5. WATER AND MOISTURE - The appliance should not be used near water. For example:
near a bathtub, kitchen sink, laundry tub, and swimming pool or even in a wet basement.
6. VENTILATION - The appliance should be situated so that its location and position does not
interfere with its proper ventilation. For example, the appliance should not be situated on a
bed, sofa, rug or similar surface that may block the ventilation openings; or, be placed in a
built-in installation, such as a bookcase or cabinet that may impede the flow of air through the
ventilation openings.
7. HEAT - The appliance should be situated away from heat sources such as radiators, heat
registers, stoves, or other appliances (including amplifiers) that produce heat.
8. POWER SOURCES - The appliance should be connected to a power supply only of the type
described in the operating instructions or as marked on the appliance.
9. GROUNDING AND POLARIZATION - Precautions should be taken to ensure that the
grounding or polarization of the appliance is correct.