ENGLISH
6
12 Then select the camera name in the “uCare Cam” app to connect.
Note: If the status LED colour does not turn orange, please check your
Wi-Fi router and make sure the IP baby monitor is within the signal
area of your Wi-Fi router. Then try this setup again.
Install your IP baby monitor by WPS connection mode
If your Wi-Fi router has a WPS (Wi-Fi Protected Setup) button, you can use it
to set up the IP baby monitor. (Must enable WPA/WPA2 encryption in Router).
On the Wi-Fi router, you will see a button labelled “WPS”. It may also be called
“QSS” or “AOSS”
1Setup Wi-Fi - WPS mode
Open the “uCare Cam” app
and select “Wi-Fi Setting” or “Wi-Fi Connect” at the bottom of the
screen.
Select the tab:
then select the tab:
to enter Step 2 (see Figure8).
2Enter WPS mode
Power on your IP baby monitor. The status LED on the IP baby monitor
will be green for about 15 seconds.
3Programme Loading
The status LED will ash red for about 15 seconds.
4Press the WPS button on your IP baby monitor
Wait until the status LED ashes between red and green, then press
and hold the WPS/RESET button on your IP baby monitor for about
2seconds to enter WPS mode. The status LED will be ashing green.
5Enter WPS mode on the Wi-Fi router
Press the WPS button on the Wi-Fi router
6Selecting the Wi-Fi router
Select the Wi-Fi router of your choice in the screen (see Figure9).
Then select the tab to enter next step (see Figure10).
