WARNING: Max Weight Capacity 350 Lbs. USE HAMMOCK STAND WITH CAUTION. INHERENT RISKS EXIST. Do not modify the
stand or hammock in any way; modification may result in failure or injury and will void your lifetime warranty.
Outpost: Setup Instructions Page 2
Outpost Mount Setup
Mount one of the clamp
plates to the ball hitch
assembly using two of
the nylock nuts and flush
head bolts.
1
Setting up the Outpost Mount
Horizontal T-Slot Mount Setup
Slide two T-slot nuts into your desired position
in the T-slot channel.
Slide two T-slot nuts into your desired
position in the T-slot channel.
Vertical T-Slot Mount Setup
1
Position the ball hitch assembly over the T-slot nuts.
Bolt securely in place using two of the hex head bolts.
2Position the ball hitch assembly over the T-slot nuts.
Bolt securely in place using two of the hex head bolts.
2
1
Insert the 4 longer hex
head bolts through the
bottom of the other
clamp plate, and position
the mount assembly on
your rack/crossbars.
*Make sure all bolts are securely
fastened to ensure the safety of
this product.
2
