Kargo Master 40280 User manual

Installation Guide
40280
Kargo Master
Rancho Cordova, CA 95742
800-343-7486
[e-mail]
DATE: ______________

For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 1
Installation Instructions –40280
*PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING,
INSTALLING, AND USING THIS PRODUCT*
Warning
Always check for wires, fuel tanks and lines, brake lines and other important vehicle
functionality items prior to drilling and installing all products.
Tools Needed
7/16” Socket and Wrench
1/2” Socket and Wrench
Phillips Driver
.25” Drill
Table of Contents
Parts List ................................................................................................................................... 2
Hardware List ........................................................................................................................... 3
Step 1 –Find Mount Location .................................................................................................. 4
Step 2 –Mount to Floor ........................................................................................................... 4
Step 3 –Mount to Shelf ........................................................................................................... 4
Before You Begin
•Read all instructions.
•Ensure safety when drilling.

For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 2
Installation Instructions –40280
Parts

For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 3
Installation Instructions –40280
Hardware

For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 4
Installation Instructions –40280
Step 1 –Find Mount Location
•Determine location of where the standing binder holder will be placed.
•Typically these are placed next to a shelf.
Step 2 –Mount to Floor
•Press the assembly firmly against the floor.
•Mount through the base of the assembly into the floor of the van using a self drilling screw
(4). Plae a spacer (5) under assembly if needed to give a flat, rigid mounting surface.
•Ensure safety prior to mounting into floor.
Step 3 –Mount to Shelf
•Use the assembly as a template. Press firmly against the shelf. Drill through the assembly into
the side of the shelf.
•Mount assembly (A) the side of a shelf using a 1/4” x 1” HH bolt, two 1/4” flat washers and a
1/4” nyloc.
GO BACK AND ENSURE ALL HARDWARE IS TIGHT
Your installation is now complete.