Kargo Master 40370 User manual

Installation Guide
40370
Kargo Master
Rancho Cordova, CA 95742
800-343-7486
[e-mail]
DATE: ______________

For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 1
Installation Instructions –40370
*PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING,
INSTALLING, AND USING THIS PRODUCT*
Warning
Always check for wires, fuel tanks and lines, brake lines and other important vehicle
functionality items prior to drilling and installing all products.
Tools Needed
Phillips driver
1/4”Drill bit (optional)
Drill
Table of Contents
Parts List ................................................................................................................................... 2
Hardware List ........................................................................................................................... 3
Step 1 - Assembly...................................................................................................................... 3
Step 2 - Installation .................................................................................................................. 4
Step 3 - Optional Installation .................................................................................................... 4
Before You Begin
•Read all instructions.
•Ensure safety when drilling.

For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 2
Installation Instructions –40370

For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 3
Installation Instructions –40370
Step 1 - Assembly
•Bolt all three pieces together as shown below. Repeat 2x.
•Use #10 x .50” Pan head screw (1) to bolt into #10 Nuts.
•Top Tray (A), sits on top of each flange on sides (B&C)

For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 4
Installation Instructions –40370
Step 2 - Installation
•Place previously assembled bin holder onto desired location.
•One can mount this part to multiple different places. These instructions show them being
mounted to KargoMaster 46” Shelf unit.
•Bolt through existing holes in shelf side panel using a 1/4” x .50” pan head screw.
•Repeat on all four locations.
Step 3 –Optional Installation
•If desired, one can move location of where the unit is installed. Place assembly where
desired, mark through the four holes.
•Drill through the previously marked holes, Replace assembly and bolt the same way as in step
2.
GO BACK AND ENSURE ALL HARDWARE IS TIGHT
Your installation is now complete.