Keithley 2510-RH User manual

PA-743 Rev. A / 9-00
Model 2510-RH
Packing List
Introduction
This packing list contains information on installation, operation, and a parts list for the Model 2510-RH Resistive Heater
Control Adapter. The Model 2510-RH (shown in Figure 1) allows the Model 2510 TEC SourceMeter to be used with a resistive
heater instead of a thermoelectric cooler.
Figure 1
2510-RH
Installation and connections
With the power off, connect the Model 2510-RH to the Model 2510 TEC SourceMeter rear panel INPUT/OUTPUT connector
(see Figure 2 for location). Connections can be made as outlined in Section 2 of the Model 2510 User’s Manual. Simply connect
the resistive heater to the equivalent Model 2510-RH OUTPUT terminals in place of the thermoelectric cooler shown on input/
output connection diagrams. Make sensor connections to equivalent Model 2510-RH INPUT terminals as needed.

2
Figure 2
Connector location for Model 2510-RH installation
Operation
To operate, turn on the Model 2510 power and set up operating modes as desired. With the Model 2510-RH installed, current
will flow through the resistive heater when the system calls for heat, and no current will flow through the heater when the system
calls for cooling, allowing the resistive heater to cool through radiation, conduction, or convection.
Refer to the Model 2510 User’s Manual for detailed operating information.
Parts list
Table 1 summarizes Model 2510-RH parts.
Table 1
Model 2510-RH parts list
Quantity
Circuit
designation Description Keithley part no.
1
1
1
1
1
1
CR1
J1
P1
4-40 Kep nut
4-40 × 3/8 Phillips pan head screw
Diode, barrier, MBR745
Connector
Connector
Heat sink
4-40KEPNUT
4-40 × 3/8 PPHSEN
RF-65
CS-834
CS-983-8
HS-33
WARNING:NO INTERNALOPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
CAUTION:FOR CONTINUED PROTECTIONAGAINSTFIRE HAZARD,REPLACE FUSE WITH SAME TYPEAND RATING.
120
LINE RATING
100-240VAC
50, 60 HZ
90VA MAX
LINE FUSE
SLOWBLOW
2.5A, 250V
!
!
CAT I
Connect 2510-RH to
INPUT/OUTPUT Connector.
Connect resistive heater to
OUTPUT terminals in place of TEC.
Model 2510 TEC SourceMeter
IEEE-488
(ENTER IEEE ADDRESS
WITH FRONT PANEL MENU)
MADE IN
U.S.A.
ENABLE-DIG I/O
RS-232
TRIGGER
LINK
OUTPUT INPUT
F+ S+ S- F- F+ F- S+ S-
ISOLATION FROM EARTH: 30V MAX.