
DPX-MP5070
9
●Test mode (Accumulated elapse time display)
• When in this mode, the mode for “Accumulated ElapseTime
Display” will be added in the MENU items at the time when
Test Mode Standby is the source. This will make it possible
to confirm on the accumulated elapse time.
MENU selection :DIMMER adjustment →…→(NAVI ATT
ON/OFF) →(CODE STBY) →Display of DC offset detec-
tion presence/absence →Accumulated Elapse Time Dis-
play.
*By pressing [ ] or [ ] key for during Accumulated
ElapseTime Display, the sources for the accumulation can
be switched.
MD TYPE MODEL (Repeating sequence : MD accumula-
tion time →CD accumulation time →MD accumulation time)
TAPE TYPE MODEL (Repeating sequence :TAPE accu-
mulation time →CD accumulation time →TAPE accumu-
lation time)
●Releasing the test mode
• The Test Mode is released by the following sequence : Re-
set, ACC OFF and ON, Power OFF and ON. Also, by ACC
OFF and POWER OFF, the Source of Tuner and Audio will
go into the initial conditions.
●Forced clearing of DC offset detection
• Regardless of the Test Mode, when power is turned on by
[SRC] key while depressing the following keys. This will be
the forced clearing of DC Err condition in the EEPOM. This
will clear the data in the EEPROM even in the case where
there is no error data.
• Key Operation
Press the [SRC] key while pressing the [DISP] and [EQ]
key at the same time.
●How to delete registered security codes
• After resetting and entering the test mode again, in the
screen for entering the security code, continue depressing
[#6] key, while depressing [#1] key. This will result in dis-
play of the character “C”on the right side of the code input
screen.
Then, using [1], [2], [3] and [4] keys of the remote control-
ler, input “KCAR”. The registered code will be deleted by
confirming the input with [S.A] key.
TEST MODE
ADJUSTMENT
BALANCE/FADER/BASS/TREBLE : CENTER
METAL/DOLBY NR : OFF
No. ITEM INPUT OUTPUT SETTINGS RECEIVER ALIGNMENT ALIGN FOR FIG.
SETTINGS SETTINGS POINTS
CASSETTE DECK SECTION
(FOIL SIDE VIEW of MAIN UNIT)
DOLBY Connect an AC voltmeter between (EQUALIZER UNIT)
1(PLAY BACK TCC-130 TA-L (Lch) andTA-G (GND), TAPE PLAY VR250A (Lch) 388mV
LEVEL) also between VR250B (Rch)
TA-R (Rch) andTA-G (GND).
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299