4008.71-00EN Rev. A S e i t e |5
(Applies only to electric variant!)
In dangerous situations, immediately press the emergency stop
button by pressing the red pushbutton.
After pressing the emergency stop button, the repair stand is
electrically disconnected and all movements are safely switched
off.
Before resetting the emergency stop button, the reason for the
hazardous situation must be eliminated. To reset the emergency
stop button, turn the pushbutton to the left or right until it
jumps back.
(Applies only to electric variant!)
When cleaning a bike on the assembly stand, avoid liquids
getting into the housing, electrical equipment or the accessory
power sockets.
Avoid cleaning under high pressure, e.g. using a water hose or
high-pressure cleaner.
The guide and spindle drive system as well as the accessory
power sockets, the hand switch or the foot switch can be
damaged by liquids getting into them.
If liquids enter electrical equipment, there is a risk of an
electrical short circuit or malfunction.
When using the repair stand with the base plate and without
further fixation, the stability factor is > 2.
To increase the stability, secure the base plate in the ground
with the enclosed bolt anchors. Make sure that the anchors are
installed correctly.
When working on the bike in the highest position, no more than
10 kg of pressure should be applied to the bike to prevent the
bike stand from falling over.
