Keysight Technologies E5818 Quick start guide

Keysight E5818 LXI Class-B
Trigger Box
Rack Mount
Installation
Note

One rack mount kit contains the hardware to mount a single E5818 onto full rack with
BNC connections on the front.

Rack Mounting Single E5818 (see other side to rack mount two E5818s)
1. Remove both rubber bumpers from the E5818.
2. Using Pozidriv screwdriver, attach Rack Ear-Half Rack (B) to the right side of the E5818 with three M4x10
Panhead Screws (C).
3. Using Pozidriv screwdriver, attach Rack Ear-Full Rack (A) to the E5818 with three M4x10 Panhead Screws (C).
Parts needed to install a single E5818 in a rack:
AE5810-00021 Rack Ear - Full Pack 1D0570-1581 Screw, Machine 4
BE5818-61200 Rack Ear - Half Rack with BNC 1E0590-0804 Nut, Machine 4
C0515-1114 Screw, Panhead, M4x10 6F8120-1839 Coaxial BNC
Cables
5
NOTE
There will be an offset of 3.2 ns when a coaxial BNC cable of approximately 610 mm length is
connected.
Rubber
Bumpers
C
C
A
B
2

4. Connect BNC cables (F). Plug AC Power Cord into AC Power port and the E5818.
5. Using Philips screwdriver, attach Rack Ears to rack with four Machine Screws (D) and four Machine Nuts (E).
Rear View of the E5818
Connect BNC cables from TTL2 out in the unit to TTL OUT 2 in the rack mount kit. Repeat the
connection for other BNC connectors.
F
1PPS 100-240 VAC
50-60Hz25VA
RS232
LAN
Act
Ln
ICES/NMB-001
ISM1-A
N10149
CUS
206349
EXT 1
IN
TTL1
OUT
EXT 2
IN
TTL 2
OUT
1PPS
TTL OUT 2 EXT I N 2 TTL OUT 1 EXT I N 1
Righ t Ver tical Rail
(Front)
D
Rack Cabinet
Par t of
E
Left Vertical Rail
(Front)
E
D
TTL2 EXT2 TTL1 EXT1 1PPS Power
OUT IN OUT IN
3

This information is subject to change without notice.
© Keysight Technologies 2007, 2008, 2015
Edition 3, January 2015
*E5818-90007*
E5818-90007
www.keysight.com