keysy KF-001 User manual

The RFID Duplicator
User Manual
Model – KF-001
Copyright Tiny La s Inc. 2017
keysy

Programming an RFID credential into Keysy:
1. Hold down the desired utton to program for 6 seconds.
2. After 6 seconds the red LED will egin linking, release the utton.
3. Place the Keysy antenna ( ehind the LED) in the center of the card/keyfo .
4. Gently move it around until the LED turns green. Keysy is now programmed.
5. After 15 seconds if no valid ID is read the LED will turn am er. If this happens flip the card/keyfo
over and repeat steps 1-4 on the other side.
6. If card fails to read after multiple attempts it may e unsupported. Feel free to email
info@tinyla s.io with an image of the device for support.
Using Keysy:
1. Press and release the previously programmed utton, the LED will flash green to indicate a valid ID
is stored.
2. Hold Keysy in front of the RFID reader. The reader should eep or link indicating a valid ID has
een read. That's it!
Copying a previously read ID onto a Keysy rewritable keyfob:
1. Hold Keysy against the rewrita le keyfo , aligning the LED in the center of the rewrita le keyfo .
2. Press the utton containing the desired ID 5 times while holding in front of the rewrita le keyfo .
3. After a short delay Keysy will either link green (success) or red (failure) 3 times.
4. If programming failed flip over the rewrita le keyfo and repeat steps 1-3.
5. After eing programmed the keyfo can e used just like the original and requires no attery.
6. Additional rewrita le keyfo s are availa le for purchase at http://tinyla s.io/keysy
ote:
Keysy consumes very little power when emulating RFID and while in an idle state. However, when
programming Keysy or rewrita le keyfo s a large amount of power is required. It is recommended to
only program with a fresh CR2032 attery. If programming fails and the attery is not fresh, replace the
attery and retry the programming sequence.
For assistance please email info@tinyla s.io.
Copyright Tiny La s Inc. 2017

Technical Specifications
Operating Frequency 125kHz
Working Temperature -30° - +60° C
Copyright Tiny La s Inc. 2017
Warning Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate
this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.