Kiddy Cots Link User manual

Kiddy Cots Link Playpen Assembly Instructions
STEP 1 - ADDING LINK CONNECTORS TO TIMBER PANELS
- slide link connector male part (A) onto end of timber panel
- insert and tighten screw in to predrilled hole
- slide link connector female part (B) onto opposite end of timber panel
- insert and tighten screw in to predrilled hole
- repeat on other ends of timber panel
- you should now have 4 link connectors on each timber panel
- see illustration as to how each panel should look when all link connectors are in
the correct position
- repeat these steps until ALL panels have link connectors
IMPORTANT: All male and female connectors must be the same on every panel.
Every panel must look the same.
STEP 2 - CONNECTING TIMBER PANELS TOGETHER
- connect panels together by lining up both top and bottom male and female parts
with the desired angle

- press down firmly to connect
- repeat with all panels choosing the desired angel for each piece
STEP 3 - DISASSEMBLY
- place downward pressure on left panel with your left hand
- pull up on adjoining right panel with your right hand, this releases the connection
between the male and female connectors
•To prevent serious injury or death, securely install enclosure and use according
to manufacturer’s instructions.
•Never use with a child able to climb over or dislodge the gate or enclosure.
•Never leave child unattended.
•Use only with the locking/latching mechanism securely engaged.
•Suitable for children from 6 months to 24 months
•This product is not to be used with a child able to climb over or dislodge/open
the playpen.
•Never use to keep child away from pool.
IMPORTANT!
•PLEASE KEEP FOR FUTURE REFERENCE.
•CLEAN PRODUCT WITH WARM WATER.
•IF ASSEMBLED ACCORDING TO INSTRUCTIONS, PLAYPEN CONFORMS TO
ATSM F1004-16B STANDARD