Kimball NARRATE User manual

NARRATE™1
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Customer Care.
Part 2964205
Assembly Instructions
1. Orient the frame correctly with the flange of the TV
mounting bracket pointing away from direction of the TV.
Mount the TV Frame like any other frame as outlined in
2997016 - Frames, Connector.
2. Ensure the mount is secured and located correctly with
the mount pushed against as far back as possible. Figure
A
3. Plug the power cord into the back of the TV and flip the
main power witch “ON” as seen in Figure B.. Refer to the
included TV manual for more detail. http://
siica.sharpusa.com/portals/0/downloads/Manuals/PN-
Y_326_436_496_556_Operation_Manual.pdf
4. Using the included M6-1 X 12mm machine screws, at-
tach the TV, locating it 3 5/16” from the flat of the lower
traxx as shown in the figure. Tighten the screws into
place. Figure C
TV Frame
Tools Required
 Cordless Drill/Driver
 3/16” Allen Bit, #2 Phillips Bit
 Tape Measure
Installation
 Level
 Pry Bar (for
leveling)
Rear View
Side View
3 5/16”
Figure B
Figure A
Figure B
TV mount
Main power switch
AC input terminal
Power cord

NARRATE™2
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Customer Care.
Part 2964205
Assembly Instructions
5. Install the IR repeater by extending the light pipe on the
TV down and placing one of the transmitters of the IR
repeater directly next to the light pipe per the included
instructions with the IR repeater. Plug the IR repeater
into the back of the USB Port on the back of the TV for
power. Figure E
6. Run the TV power cord through the center cutout in the
frame and plug into the receptacles on the outside of the
frame. Run the IR repeater Receiver outside of the panel
through the cutouts in the middle of the frame and exit
out of the wireway cover. Place the IR repeater receiver
in a visible location using the adhesive back. Figure D
Installation (Continued)
Rear View
Figure D
Figure E
Slide the lever on the rear of the monitor to
pull out the power LED/remote control sensor.
Press the power LED/remote control sensor
directly to store it inside the monitor.
How to pull out the power LED/remote control sensor
Lever
USB port
Power LED remote
control sensor