3 Attaching the cymbal pads
[1] Attach the Cymbal holders to the Holder clamps on the
Side Arms.
[2] Tighten the wing nuts on the Holder clamps.
[3] Remove the wing nut and the felt washer of each
Cymbal holders.
[4] Attach the Cymbal pads to the cymbal holders.
[5] Reattach the felt washer and wing nut,
tighten the wing nut of each cymbal holders.
[1]
[2]
[5] [5]
[3] [4]
Drum Pad Assembly
Holder clamp
Holder clamp Holder clamp
Holder clamp
[5] [5]
Wing nut
Cymbal holder (S)
Cymbal holder (L)
[1],[2]
[1],[2]
[1],[2]
2 Attaching the drum pads
[1] Loosen the wing nuts on the
drum pads .
[2] Remove the Metal Rods.
[3] Reattach the Metal Rods to
the drum pads.
[4] Tighten the wing nuts securely.
[5] Attach the drum pads assemblies to the holder clamps and adjust their position,
then tighten the wing nuts on the Holder clamps.
Assembly
1 Setting up the frame of the digital drum set
[1] Attach the Pillar (L) to the clamp on the Leg (L).
[2] Using the drum key, tighten the screws on the clamp.
[3] Remove the screw attached to the connector.
[4] Attach the cross pipe to the connector.
[5] Reattach the screw into the connector
[6] Tighten the screw on the connector.
[7] Attach the Pillar (R) to the clamp on the Leg (R).
[8] Tighten the screws on the clamp.
[9] Attach Center Pipe to the clamp on the Leg (L).
[10] Tighten the screws on the clamp.
[11] Attach the Right Leg Assembly to the Center Pipe.
[12] Tighten the screws on the clamp.
[13] Remove the screw attached to the connector
[14] Attach the cross pipe to the connector.
[15] Reattach the screw into the connector.
[16] Tighten the screw on the connector.
Pillar (L)
Leg (L)[2]
[1]
[3],[5],[6]
[4]
[6]
Left Leg Assembly
[10]
[9]
Center Pipe Center Pipe
[11]
[12]
[17] Attach the Side Arm (L1) to the clamp on the Pillar (L) .
[18] Tighten the screws on the clamp.
[19] Attach the Side Arm (L2) to the clamp on the Pillar (L).
[20] Tighten the screws on the clamp.
[21] Attach the Side Arm (R) to the clamp on the Pillar (R)
[22] Tighten the screws on the clamp.
Pillar (L)
[17]
Pillar (L)
[18]
[19]
Pillar (L)
[20]
Pillar (R)
Leg (R) [8]
[7]
Right Leg Assembly
[13],[15],[16]
[14]
[16]
[21]
Pillar (R)
[22]
Side Arm (L1)
Side Arm (L2) Side Arm (R)
Side Arm (L1)
Cross pipe
Cross pipe
Wing nut Wing nut
Felt washer Felt washer
[3] [3]
[3] [3]
[4],[5]
Wing nut
Felt washer
Cymbal holder (L)Cymbal holder (S)
