
Décor Grid Rack
DR 25
Thank you for selecting Enclume.
Our Décor racks bring you the best in
Quality, craftsmanship and style.
You will not be disappointed.
WARNING: PLEASE READ
ALL OF THESE INSTRUCTIONS BEFORE
ASSEMBLING AND USING YOUR RACK
Enclosed you will find everything needed*
for the installation and use of your pot rack.
Two people can make rack installation
much easier. Parts and hardware included are:
Hardware included:
4 –Wall Clips
4 –1 ½” Wood Screws
4 –Wood Screw Sleeves (red)
------------------------------
*A drill for making four holes is not included
INSTALLATION INSTRUCTIONS
1) Unpack the rack, spread out the contents, and match the rack parts
to the hardware and component lists above. If any item is missing,
call our customer service line at 1-877-362-5863 for replacements.
2) Decide where your wall the grid rack is going to be located. Note: the rack may be installed vertically, as shown in the
above photo and diagram, or horizontally.
3) Hold the Wall Grid in the location where it will be installed, hold a Wall Clip over the second grid wire from each end
of the top of the Wall Grid, and mark where the screw hole needs to be drilled. Repeat for the bottom, and mark for
two screw holes will be drilled there
4) If you are attaching your rack to the solid wood of wall studs you will use the Wood Screws alone.
5) If you are mounting on a wall of drywall you will be inserting the Wood Screw Sleeves first, then the Wood Screws.
6) Decide whether you will use the Wood Screws alone (wood) or the Wood Screw Sleeves with the Wood Screws
(dry wall) for mounting and then proceed to drill small starter holes where marked for the Wood Screws, or 9/32 holes
for the Wood Screw Sleeves.
** PLEASE TURN INSTRUCTION OVER **
DR25 Décor Grid Rack PAGE 2
Components included:
1 –Wall Grid
6 –Pot hooks - DRPHS