© KLING & FREITAG GMBH Version 1.4 Page 7 of 15
User's Manual K&F VIDA L Adapter Plate
Raised speakers mounted to each other can be considered a stand.
3. Safety Instructions
3.1 General Safety Instructions
The information described here does not relieve the user of the duty to follow the given safety require-
ments and legal regulations.
The component is designed for operation on horizontal grounds. There must be no risk of persons run-
ning into the setup as well as no wind loads in normal operation; otherwise, be sure to take appropriate
additional measures to prepare for such circumstances.
Always follow the technical documentation and the structural certifications on the H.O.F. Alutec website.
Only qualified technicians are permitted to perform the installation steps. Be sure to use personal protec-
tive equipment at all times.
The technicians responsible for installing the system on site are responsible for and guarantee safe setup
and use.
To prevent injury and damage, be sure to securely place the speaker system as specified in the DGUV
regulations 17 (BGV C1) or similar locally applicable accident-control standards.
Unless otherwise stated, use only KLING & FREITAG original parts for mounting the speakers. Never use
other parts (in particular, parts not made by KLING & FREITAG).
Be sure to always visually inspect all accessories and loudspeakers before use. In fixed installations, reg-
ularly check all system components for signs of wear. Visual inspection includes checking the system
components of the speakers as well as the mounting components. During the inspection, check all
mounting components carefully for deformations, cracks, bolt damage, and corrosion. If there are signs
of wear, cracks, or deformation, etc., replace the affected parts immediately.
See also the ‘Care and
3.2 Safety Instructions When Mounting the System as a Stand
Never place stands on emergency escape routes.
For any application, always have a proof of stability issued.
This can be done on the basis of the structural analysis available on the manufacturer's website at http:/
/excellent-line.de/pdf/ELD4_Statik.pdf.
The proof of stability must be issued by a qualified event technician or a structural engineer.
Remember that placing speakers onto or removing them from speaker-stands poses specific risks. Be sure
to use means suitable for the purpose (for example, platforms).
If you put up the stand in a public area, establish a minimum height of 1.6 meters (5¼’) from the floor
to the bottom edge of the speaker.
Depending on the application at hand, you can mount up to 2 VIDA L or 2 VIDA L plus 2 VIDA C onto
the specified stand using the adapter plate.
