Page 8 of 15 Version 1.0 © KLING & FREITAG GMBH
User's Manual
SPECTRA 212i Ceiling Bracket1.016.06.20 2106/16/20 21
K&F SPECTRA 212i Ceiling Bracket
3 Safety Instructions
Risks imposed by falling or overturning parts
•Be sure to install, suspend, fasten, and use Kling & Freitag speaker accessories only using
the designated fixtures as specified in this document.
•Be sure to use only the screws supplied with the speaker for mounting accessories. The
screws are specifically designed for accessory mounting. Be sure to use self-locking screws
no more than five times. Using them more often may result in screws loosening in opera-
tion. If in doubt, use new screws. Never use other types of screws.
•During installation, be sure to cordon off the installation site to prevent any risks caused
by falling parts.
Safety Instructions for Suspending the Speakers
Suspended loads pose a safety risk.
•All installation works including suspension as well as ceiling mount to be performed by
qualified event technicians or appropriately trained persons.
•Only qualified technicians are permitted to perform the installation steps. Be sure to use
personal protective equipment at all times.
•Be sure to have all works carried out by untrained hands checked and approved by a qual-
ified expert.
•The technicians installing the speaker on site are responsible for and guarantee safe setup
and use.
•Installing and dismounting the speaker system requires two persons or a suitable lift for
carrying and handling.
•Before installing, check the stability, strength, and materials of walls, ceilings, and board-
ing. For example, always use appropriate wall anchors for panels and check for sufficient
strength.
•Note that the suspension points on the hall ceiling (i.e. shackles, attachment points, or
chain hoists) must comply with the DGUV regulations 17 (BGV C1) or similar locally appli-
cable accident-control standards. The maximum load must have been certified by an
authorized expert.
•Be sure to tighten all bolts and screws to the specified torque.
•Unless otherwise stated, use only KLING & FREITAG original parts for mounting the speak-
ers. Never use other parts (in particular, parts not made by KLING & FREITAG).
•Make sure all fittings used are suitable for the task at hand and meet all relevant safety
requirements.
•Ensure that all connections are secured against coming loose and that only authorized,
statically tested and correctly sized supports, mounting equipment, wire ropes and chains
are used.
•Be sure to always visually inspect all safety-related speaker and accessory components be-
fore use. If there are signs of wear, cracks, or deformation, etc., replace the affected parts
immediately. Visual inspection also includes checking all screwed connections of support-
ing components.
•The information described here does not relieve the user of the duty to follow the given
safety requirements and legal regulations.
